7. Replace any adapters that you removed in step 3. Close the front
adapter-retention bracket and replace the rear adapter-retention bracket.
8. Replace the cover (see “Replacing the side cover” on page 51).
9. Reconnect the external cables and power cords. Turn on the attached devices,
and turn on the computer.
10. Use the SCSISelect program to configure SCSI channel A.
Installing a security rope clip
Tohelp prevent hardware theft, you can add a security rope clip and cable to your
computer.After you add the security cable, make sure that it does not interfere with
other cables that are connected to the computer.
Before you begin, obtain the following items:
vA flat-blade screwdriver
vAn adjustable wrench
vA 19-mm (0.75-in.) rope clip or wire rope (similar to National Manufacturing
number 3230, stock number 176-735)
vThreaded nuts that fit the rope clip
vA security cable
vA lock, such as a combination lock or padlock
Complete the following steps to install a rope clip:
1. Turn off the computer and all attached devices.
2. Disconnect all external cables and power cords; then, remove the side cover.
See “Removing the side cover” on page 25
3. Use a screwdriver to remove the two metal knockouts.
4. Insert the rope clip through the rear panel; then, attach and tighten the nuts.
Chapter4. Installing options 49