Card/bracket assembly
Note:
vRead “Installation guidelines” on page 23.
vRead the safety notices at AppendixB, “Safety information,” on page 127.
vRead “Handling static-sensitive devices” on page 23.
Complete the following steps to remove the card/bracket connector assembly:
1. Turn off the computer and attached devices.
2. Disconnect the power cord from the power source and from the computer; then,
disconnect all external cables.
3. Remove the side cover (see “Removing the side cover” on page 25.
4. Remove the front bezel (see “Removing the bezel” on page 26).
5. Press the latch on the top of the assembly; this side of the assembly will detach
from the chassis.
6. Remove the tab on the bottom part of the assembly from the slot in the chassis.
7. Pull the assembly out slightly and detach the two cables from the back of the
assembly.
Toinstall the card/bracket connector assembly, reverse the previous steps, placing
the bottom tab into the slot in the chassis and then pressing the top of the
assembly into place.
Chapter5. Field replaceable units 69