5. Refer to Figure 11.
Figure 11. Closing the Handle of a Disk Drive Module
6.While continuing to push the disk drive module into the slot, slowly close the handle 1 until it stops with a click. This action pushes the module fully home.
7.Verify that the disk drive module that you have just installed is aligned with the sides of the 2104 and that no gap exists between this module and the modules that are next to it.
Verify also that the front edge of this disk drive module aligns with the front edges of the modules that are next to it.
If the disk drive module is not correctly aligned, remove it (see “Removing the Disk Drive Modules and Dummy Disk Drive Modules” on page 7) and reinstall it (steps 2 through 6 above).
8.Repeat steps 2 through 7 for each disk drive module.
Attention: Any slot that has no disk drive module installed must contain a dummy disk drive module. The dummy disk drive module ensures that the correct airflow is maintained around the disk drive modules in the other slots.
162104 Model DU3 Installation Guide
