IBM ED-X10/ED-X12 Putting batteries, Remote control

Remote control

Remote control

Putting batteries

WARNING ►Always handle the batteries with care and use them only as directed. Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire.

And also improper use may result in cracking or leakage, which could result in fire, injury and/or pollution of the surrounding environment.

•Be sure to use only the batteries specified. Do not use batteries of different types at the same time. Do not mix a new battery with used one.

•Make sure the plus and minus terminals are correctly aligned when loading a battery.

•Keep a battery away from children and pets. If swallowed consult a physician immediately for emergency treatment.

•Do not short circuit or solder a battery.

•Do not allow a battery in a fire or water. Keep batteries in a dark, cool and dry place.

•If you observe a leakage of a battery, wipe out the flower and then replace a battery.

If the liquid adheres to your body or clothes, rinse well with water immediately.

•Obey the local laws on disposing the battery.

1.

2.

3.

Remove the battery cover.

Slide back and remove the battery cover in the direction of the arrow.

Insert the batteries.

Align and insert the two AA batteries according to their plus and minus terminals as indicated in the remote control.

Close the battery cover.

Replace the battery cover in the direction of the arrow and snap it back into place.

15

Contents

About this manual Content Projector features Preparations About contents of package Fastening the lens cover Part names Projector (*) About Restart switch: Control buttons Remote control Settingup Arrangement Adjusting the projector's elevator Using the Security Bar Connecting your devices Examples of connection with a computer Connecting to a monitor (output) Connecting to a speaker with amplifier (output) Examples of connection with a VCR/DVD player Connecting power supply Remote control Putting batteries Using the remote control Power on/off Turning on the power Turning off the power Operating Adjusting the volume Temporarily muting the sound Selecting an input signal Searching an input signal Selecting an aspect ratio Adjusting the zoom and focus Using the automatic adjustment feature Adjusting the position Correcting the keystone distortions Using the magnify feature Freezing the screen Temporarily blanking the screen Operating the computer screen Multifunctionalsettings Using the menu function EASY Menu EASY Menu (continued) PICTUREMenu PICTURE Menu (continued) Page IMAGEMenu IMAGE Menu (continued) INPUTMenu INPUT Menu (continued) Page SETUP Menu SETUP Menu (continued) SCREEN Menu SCREEN Menu (continued) below Page OPTION Menu OPTION Menu (continued) Page Page 1.Using Security Features 2. Using the MyScreen PASSWORD Function PASSWORD 3. Using the PIN LOCK Function Page 4. Using the Transition Detector Function Transition Detector Page Lamp WARNING Lamp (continued) Type number = DT00757 In the case of replacement by yourself Air filter Air filter (continued) Other care Troubleshooting Related messages Regarding the indicator lamps Regarding the indicator lamps (continued) The cooling fan is not operating There is a possibility that the interior portion has become heated It is time to clean the air filter Phenomena that may be easy to be mistaken for machine defects operation sometimes resolves your problem If the situation cannot be corrected the projector will restart The electrical power cord is not plugged in Phenomena that may be easy to be mistaken for machine defects (continued) The MUTE function is working The volume is adjusted to an extremely low level The AUDIO setting is not correct The lens cap is attached The brightness and/or contrast are adjusted to an extremely low level The WHISPER function is working The lamp is approaching the end of its product lifetime Warranty and after-service Specifications Specifications (continued)