IBM specifications Installation, What You Have, ETX-DB-ATX Board Layout, Etx-Db-Atx

*ISA interface: One ISA slots.

*10/100Mbps Ethernet Controller: Intel 82551QM or Realtek RTL8100 IEEE802.u 100 BASE-TX standard Dual Auto-sensing interface to 10MBps or 100MBps networks. On board RJ45 connectors provide for easy connection.

*Power connector: standard ATX power connector

*Dimension: 304mm x 190mm

1.2What You Have

Before you begin installing the product, please check the following materials are included in the package:

•1 ETX-DB-ATX ETX module baseboard

•1 3.5” IDE flat cable (ATA-66, 44 pin 2.54mm pitch, 457mm)(32200-000052)

•1 floppy cable (for 3.5” FDD only) (32200-000017)

•1 serial port cable (for RS232) (32200-0000??)

If any of these items are missing or damaged, contact your distributor or sales representative immediately.

2 Installation

This chapter gives instructions about how to set up the ETX-DB-ATX hardware, including directions of connecting peripherals. Before installation, please pay attention to the unpacking precautions on the following page for safety.

2.1 ETX-DB-ATX Board Layout

5 ETX-DB-ATX ETX-DB-ATX 6