IBM PC 300PL manual Recovery jumper, Cable connectors, Dvi, Description

Chapter	2.		System			board features
Some	desktop				models have a riser card with two PCI slots, one		ISA slot, and one share
The following					illustration shows the location of the slot on the		PCI/ISA riser card.
.1/PCI	slot			3
.2/PCI	slot			2
.3/Alert		on		LAN	connector
.4/SCSI	LED		connector
.5/Wake		on	LAN		connector
.6/FDD	connector
.7/Fan	connector
.8/Tamper		detector				connector
.9/Speaker			connector
.1ð/RFID		connector
.11/Power		LEDs
.12/ISA	slot
.13/ISA	slot
.14/System			board connector
.15/PCI	slot			1
.16/CD	audio			connector

PC 300PL — tower model

The following illustration shows the riser card on the tower model.

.1/PCI slots 1-5, lowest to highest

.2/Diskette drive connector

.3/Hard disk fan 1 connector

.4/Hard disk fan 2 connector

.5/Front fan connector

.6/Wake on LAN connector

.7/RFID connector

.8/Speaker connector

.9/Tamper detector connector

.1ð/SCSI LED connector

.11/IDE secondary connector

.12/IDE primary connector

.13/Power connector

.14/Alert on LAN connector

.15/212-pin system board connector

.16/CD audio connector

Recovery jumper

The recovery jumper on the				system board is used for custom				configurations. For the loc
recovery			jumper, see the	“System board, Types 6584			and 6594”	on page 13.
Figure		6.	Recovery jumper
Pins					Description
1	and	2			Normal	(factory	default)
2	and	3			Clear	CMOS/password, boot block		recovery

Cable connectors

Connections for attaching devices are provided on the back of the computer. The connec

ŸUSB (2)

ŸMouse

ŸKeyboard

ŸSerial (2)

ŸParallel

Ÿ	Monitor	(SVGA or	DVI)
Ÿ	Audio	connectors	for line in, line/headphone out, and microphone

14 Technical Information Manual