Use this option to change the I/O type of the primary I/O book after a service
action or configuration change if the I/O type is incorrect. If this option is chosen,
you will be asked to make the following entries:
- For the I/O drawer address, type 1.
- For the I/O type, type 98.
If either value is not valid, a failure message displays on the console. Press Enter
to return to the Power Control Network Utilities Menu.
vLED Control Menu
This menu displays the state of the processor subsystem disturbance or system
attention LED and the fault/identify LED on the I/O subsystem(s). Use this menu to
toggle the attention/fault LEDs between identify (blinking) and off. Option 1 is
available only when the system is in the error state (the CEC is powered on and the
service processor menus are available). Option 1 is not available when the system is
in standby.
An example of this menu follows:
LED Control Menu
1. Set/Reset Identify LED state
2. Clear System Attention Indicator
98. Return to Previous Menu
0>
The processor subsystem disturbance or system attention LED is located on the
operator panel in the media drawer. The I/O drawer fault/identify LED is located on
the front of each I/O subsystem.
If option 1 is selected, a list of location codes of the I/O subsystems and the CEC
drawer displays. The screen will be similar to the following:
38 Eserver pSeries 690 User’s Guide