After choosing which adapter to use to ping the remote system, and setting its
parameters, you must provide the addresses needed to communicate with the remote
system.
Ping Test
1. Client IP Address [129.132.4.20]
2. Server IP Address [129.132.4.10]
3. Gateway IP Address [129.132.4.30]
4. Subnet Mask [255.255.255.0]
5. Execute Ping Test
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen X = eXit System Management Services
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
If changes to the adapter parameters must be made in this screen, entering those
changes will not automatically update the Adapter Parameters screen. Go back to the
adapter parameters menu to make any changes.
Notes:
1. After the ping test is initiated, it might take up to 60 seconds to return a result.
2. When the ping test completes, the firmware stops and waits for a key to be pressed
before continuing.
Change SCSI Settings
This option allow you to view and change the addresses of the SCSI controllers
attached to your system.
SCSI Utilities
1. Hardware Spin Up Delay
2. Change SCSI Id
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen X = eXit System Management Services
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
Chapter 4. Using System Management Services 75