Icom IC-M32 instruction manual Battery pack, To remove the battery pack

SUPPLIED ACCESSORIES AND ATTACHMENTS 2

ïBattery pack

To remove the battery pack:

Turn the screw counterclockwise, then pull the battery pack in the direction of the arrow as shown below.

To attach the battery pack:

Insert the battery pack in the IC-M32 completely, then turn the screw clockwise.

NEVER remove or insert the battery pack when the trans- ceiver is wet or soiled. This may result water or dust get- ting into the transceiver/battery pack and may result in the transceiver being damaged.

Screw position

when removing battery

LO	CK
OPEN

Screw position

when attaching battery

LO	CK
OPEN

NOTE: When removing or attaching the battery pack, use

a coin or flat-blade screwdriver to loosen or tighten the bot- 2 tom screw.

CAUTION!:

When attaching or removing a battery pack, make sure the rubber seal is set in the groove of the battery pack cor- rectly. If the seal is not neatly in the groove it may be dam- aged when attaching the battery pack.

If the seal is damaged, waterproofing is not guaranteed.

NOTE:

When attaching a battery pack, make sure dust or else does not adhere to the rubber seal. If dust or else is on the seal when attaching a battery pack, the water resistant may be reduced.

Make sure both the rubber seal (purple) is set to the groove correctly and dust or else does not adhere to it.

Correct position	Incorrect position
	Rubber seal
	Groove
Battery pack	Battery pack

3