IDEAL INDUSTRIES 45-930, 45-935 operation manual STP Operation Set Mode

1—WARN ON 2—WARN OFF

3—SET LIM 4—CLR CNT

STP Operation continued

Set Mode

1—INCR 2—CODE 3—UNIT

4—LOCK OUT 5—COUNT

1 — STRIP LENGTH INCREMENT

SET STRIPLENGTH	SET STRIPLENGTH
INCREMENT 0.00 IN	INCREMENT 0 MM

This allows programming the strip length in increments by using the arrow keys to increase or decrease the length appearing on the display. ENGLISH LENGTH MODE - (0.01 in. to 0.99 in.) The tenths position begins blinking. After the tenths digit is entered, the hundredth position blinks. After the hundredth digit is entered the unit will automatically return to ready mode.

METRIC LENGTH MODE - (1 mm to 99 mm) Enter the increment length, 1mm to 9 mm, and press ENTER. Increment lengths of 10 mm to 99 mm are automatically entered after being typed in.

2 — SECURITY CODE

ENTER NEW CODE

NEW CODE =

Enter the new 3-digit code. CLEAR can be pressed any time during this process and the current 3-digit code is restored.

3 — SELECT UNITS (IN/MM)

SELECT

1—ENGLISH 2—METRIC

This allows the selection of English or metric units. Press [1] for English or [2] for metric.

4 — KEYBOARD LOCKOUT

LOCK OUT

1—LOCK ON 2—LOCK OFF

This allows locking out everything on the keyboard except for calling up batches and adjusting the strip length. Press [1] for lock on or [2] for lock off.

5 — COUNTS

There is an 8-digit counter that starts at 0 when the machine is built and counts every cycle. This counter is nonresettable. There is a 6-digit counter that counts every cycle and is resettable.

[1] (Warning On) activates the “SERVICE MACHINE” warning that appears at the end of a cycle if the resettable count is equal to or above the limit that has been set.

[2] (Warning Off) disables the “SERVICE MACHINE” warning.

[3] (Set Service Limit) allows setting the limit of cycles to when the warning should go off (from 0 to 999999). This also is a reminder to reset the count.

[4] (Clear Service Count) resets the count.

When the service count is reached a warning is flashed at the end of every cycle if the “warning on” is set.

The counts can be displayed during the ready mode by pressing and holding down COUNT. When the COUNT key is released, the display returns to the ready to strip mode.

10