IDEAL INDUSTRIES 45-935, 45-930 operation manual Blade Replacement

Models: 45-930 45-935

1 23

Page 15

1.Electronically set strip length to 6". This moves the stop bar all the way back allowing more room to replace the blades.

2.Disconnect power. (rear gripper will retract all the way back).

3.Disconnect air.

4.Open lid. Note: Open lid by pressing button and lifting lid.

5.Unplug blade electrical connection and cut off connector (a new connector is supplied with replacement blade set).

CUT OFF CONNECTOR

6.Remove the two hold-down clamps.

7.Unplug the wire connection between the two blades (inside silicone tube).

Image 15

Contents

Shielded Twisted Pair STP Cable Stripping System Table of Contents Shielded Twisted Pair STP Cable Stripping SystemIntroduction Unpacking Warranty & Service PolicySTP Service Setup Qualified Service Personnel Environmental ConditionsAir Connection Requirements STP Service SetupSTP Operating Principles and Terms Electrical Connection RequirementsSTP Operation Example Ready Mode DisplayExample Heat AdjustmentThermal Head Rotation Speed Adjustment Pull Grip Pressure AdjustmentNormal Strip Cycle Strip Length Adjustment, by Discrete ValueCycle Mode Metric Length Mode 31 mm to 152 mm Press Strip LengthDouble CUT Cycle TWO Stage CycleRepeating Cycle Set ModeSlug Removal Single CycleSTP Operation Set Mode Blade Home Sensor STP Service Qualified personnel onlySTP Operation Batching Test the SensorsRecommended Replacement Parts STP ServiceHoses do not interfere STP Operation Gripper Pad ReplacementFront Gripper Pad Replacement Pressing buttons and lifting lidTension Springs Rear Gripper Pad ReplacementBlade Replacement Rear View Replacement Blade set consistsBlade Set K-7763 Front ViewPower Module Replacement CPU Module ReplacementChanging Slug Tray Location Tips and Trouble ShootingPreventative Maintenance Cleaning Your STPQty Name STP Machine AssemblyTop Shelf Assembly Rear Gripper Assembly Electrical Wiring Diagram Ideal INDUSTRIES, INC