6
STP Operation continued
Heat Adjustment

Heat can be adjusted by pressing [0] through [9] producing corresponding heat values of 0% through 90%. Pressing HIGHsets the heat at 100%. If

the heat is set at 0%, the machine completes the cycle without using the blades. The heat can also be adjusted by pressing HEATand using the [ ]

and [ ] keys. The heat is adjusted from 0% to 100% in increments of 10%. Pressing the ENTERkey exits from the heat entry mode and returns to the

ready mode.

If CLEARis pressed during a HEAT entry, it returns to the beginning of the HEAT entry mode. If CLEAR is pressed at the beginning of the HEAT entry

mode, it exits the HEATentry mode and the previous settings are returned.

Thermal Head Rotation Speed Adjustment

Speed can be adjusted by pressing [1] through [9] corresponding to speeds 1 through 9, and pressing HIGHfor speed 10.The speed at which the

thermal blades rotate around the wire being stripped can also be adjusted by pressing SPEEDand using the [ ] and [ ] keys. The speed is set from 1

to 10, the fastest setting being 10. Pressing the ENTERkey exits from the speed adjustment mode and returns to the run mode.

If CLEARis pressed during a SPEED entry, it returns to the beginning of the SPEED entry mode. If CLEAR is pressed at the beginning of the SPEED

entry mode, it exits the SPEEDentry mode and the previous settings are returned.

Pull Grip Pressure Adjustment

Pressure can be adjusted by pressing the numbers corresponding to pressures 05% through 95%, pressing HIGH sets the pressure at 100%.

EXAMPLE:

press [4] then [5] to get pressure at 45%.

The pressure can also be adjusted by pressing PRESSUREand using the [ ] and [ ] keys. Pressure can be

adjusted from 5 to 100 PSI in increments of 5 PSI. Pressing the ENTERkey exits from the pressure entry mode and returns to the ready mode.

If CLEARis pressed during a PRESSURE entry, the display returns to the beginning of the PRESSURE entry mode. If CLEAR is pressed at the

beginning of the PRESSUREentry mode, the display exits the PRESSURE entry mode and the previous settings are returned.

↑
↑
Press HEAT Field will Flash or
Press Press Press
HEAT
20%
ENTER VALUE
10 40 3.10
Press To
Enter Single
Digit Value
BATCH
ENTER
PRGM.
HIGH
Or Press for
100% Heat
HEAT Field will Flash
20%
ENTER VALUE
10 40 3.10
ENTER HEAT
20%
ENTER VALUE
40 3.1010
SPEED
Press SPEED Field will Flash or
20%
ENTER VALUE
40 3.1010
Press Press
ENTER
Press To
Enter Single
Digit Value
BATCH
ENTER
PRGM.
HIGH
Or Press for
Speed 10
SPEED Field will Flash
Press
SPEED
Example 1 Example 2
Example 1 Example 2
↑
↑
20%
ENTER VALUE
3.1010 45
PRESSURE
Press PRESSURE Field will Flash or
20%
ENTER VALUE
3.1010 40
Press Press
ENTER
Press
PRESSURE
Press To
Enter Single
Digit Value
BATCH
ENTER
PRGM.
HIGH
Or Press for
100%
Pressure
PRESSURE Field will Flash
Example 1 Example 2
↑
↑