iHome iBT52 instruction manual Connecting Receiver to Speaker Using Aux Out

2.Move the Power On/Off Switch to the ON position (right) and wait 3 seconds to listen to audio streamed wirelessly from your paired iPad, iPhone, iPod or other Bluetooth device.

The Button/Indicator Light on the Receiver will flash blue as the unit searches for a previously paired device, and then flash blue twice every 7 seconds once a previously paired device is detected.

3.Press the Button to play or pause tracks. Use the controls on your device to navigate tracks and control volume from your Bluetooth device.

4.When done listening, move the Power On/Off Switch to the OFF position (left) to turn the unit off.

Connecting Receiver to Speaker Using Aux Out

While the Bluetooth Receiver is docked in the Docking Station, you can connect the Docking Station to any external speaker or audio device with a speaker and aux/line-in jack via the Aux-out cable attached to the Docking Station.

You can also connect the Bluetooth Receiver directly by connecting a standard 3.5mm stereo audio cable to the Aux-out jack on the Bluetooth Receiver and the other end into the desired Line-in jack.

1.Connect a 3.5 mm audio cable plug to the Aux-out jack on back of the unit and connect the other end to the line-in jack on your external speaker. Note that the aux output signal is stereo.

2.Move the Power On/Off Switch to the ON position (right) to listen to audio via the selected mode.

3.Power on the audio device and use the controls on the device to navigate tracks and control volume. Press the Button to play or pause tracks.

4.When done listening, move the Power On/Off Switch to the OFF position (left) to turn the unit off. Remember to turn off your audio device, too.

Aux-in

DC 12V	usb
2.5A	charging

to power source