Option C - Connecting with your Mac or PC over Wi-Fi
To connect your iW3 speaker to a | 1 |
|
follow these steps: | powernetwork setup | |
|
| off on |
|
| power |
1. Connect AC power and power ON the iW3 speaker. |
| off on |
2.Press and hold (5 sec.) Network Setup button on the back of unit.
Note: The Network Status LED will begin flashing green and the top 3 AirPort: On
2 | power | network setup |
| off on | |
| status | network setup |
Currently connected to:
YOUR
control panel will also flash.
Turn AirPort Off
Internet access
iHome Setup ######
Your
3. On your Mac or PC, select the network called "iHome Setup ######"Another network
iHome Setup ######
Information sent over this network might be visible to others.
from
Another network
Join Other Network...
Create Network...
Connect
Open Network and Sharing Center
Note: This process can take up to 2 minutes. Be patient and refresh yourOpen Network Preferences...
9:42
network list if necessary.
4. Launch a web browser (ex. Safari, Chrome, or Firefox) and enter http://192.168.1.12 in the address bar.
upper right corner of Mac screen
01/15/2011
lower right corner of PC Screen
Note: If the page is not initially available or becomes unresponsive, reload the page. See“troubleshooting” if problem persists.
5.Rename the iW3 speaker and click‘Apply’. (optional)
6.Select the‘Networking Tab’, click‘Configure Network Settings’, choose preferred
30-120s 30-120s
4 | http://192.168.1.12 |
For support and product information, visit
www.ihomeaudio.com/support
Note: Connecting to a network may take up to 120 seconds. If network connection is unsuccessful reset the iW3 by powering OFF/ON again and then repeat the above steps.
Success!
1.Verify that the Network Status LED is green to confirm if the iW3 is successfully connected to a network.
2.Disconnect from“iHome Setup ######” and connect your Mac/PC to the same network you connected the iW3 speaker.
3.Keep reading to learn how to use the iW3 to stream and control your iTunes and iOS audio content.
5 | Device Name |
| |
|
|
| Networking |
|
|
Model: iW3
Firmware: 08.0.0
MACMAC addressaddress:: a3:4b:61:e5:24:22a3:4b:61 :e5:24:22
http://192.168.1.12
Device name
This name will be used when your speaker appears in a list of available AirPlay devices.
iHome iW3 XXXXXX | Apply |
| status | network setup |
| status | network setup |
|
|
|
|
|
|
For support and product information, visit
www.ihomeaudio.com/support
Device Name
6 |
| Network status: Not Connected |
Networking | SSID: not available | |
|
| Type: not available |
|
| |
| Model: iW3 | IP address: 192.168.1.12 |
|
| |
| Firmware: 08.0.0 | Signal strength: excellent |
|
| |
| MAC address: a3:4b:61:e5:24:22 | Configure Network Settings... |
Connected | Not Connected | Problem? |
|
|
Note: Your AirPlay source devices (Mac or PC with your iTunes library as well as your iPod touch, iPhone or iPad) must be connected to the same
SSID: Available Networks
Password: •••••••••
Automatic IP address (DHCP): On Off
Apply
English | 10 |