iHome iW3 Firmware update continued, Option C - Firmware update using Mac/PC, English, no LEDs

Firmware update continued...

Option C - Firmware update using Mac/PC

Follow these steps to update the firmware of your iW3 speaker using only your Mac or PC. Please note that we recommend trying option A or B before attempting this method.

1.Using your computer visit: www.ihomeaudio.com/support/product/iW3 and download the latest firmware from the top right corner of the support page. Please be sure to remember the location where you save the file to on your computer.

http://10.0.1.2

Device Name

For support and product information, visit

www.ihomeaudio.com/support

2.Verify that your iW3 is successfully connected to your home network.

3.Open a web browser (we recommend Safari) and access the iHome Device Management webpage by using Bonjour services or directly typing in the iW3’s IP address. The IP address can be found using iHome Set under network details or by re-initiating the network setup mode on page 10.

Note: Make sure that you have enabled Bonjour service in your

PC. Take Windows XP for example: to enable the service, you can click Start->Settings->Control Panel, and double click Adminis- trative Tools-> Services->Bonjour Service, then click Start followed by OK on the pop-up menu.

4.If everything was done correctly you'll see the page pictured.

5.Click the "Firmware" tab on the left column and follow the on-screen instructions.

During Firmware Update:

Networking

Firmware

Model: iW3

Firmware: 08.0.0

MAC address: a3:4b:61:e5:24:22

Current Firmware Version : 00.0.0

To update the firmware of this device, you must first visit iHomeaudio.com/support and download the latest firmware for this speaker.

Once you have the new firmware file, you can initiate the firmware update process.

Begin Update

Note: If a file selection interface does not appear in approximately 30 seconds, you may try reloading this page using the reload button on your web browser.

You can only complete firmware update using this page from a PC or Mac.

1.The top panel LED's will light up in succession to note the progress of the update (see diagram below)

2.The iW3’s device management web page will indicate progress.

The iW3 will restart if firmware update is successful.

Note: This process can take 4-5 minutes.

no LEDs

installation = 0% 25% 50% 75% 100%

English 13