iHome iW3 Quick Start, Power, iPod Local Audio Mode, English, Press power button, power source

Quick Start

Power

1 Connect charging base to 2 Place iW3 on charging base 3 Turn master power switch ON	4 Press power button
power source

outlet

12V

powernetwork setup

off on power

off on

allow 30 seconds	pressing the power button will switch
for the iW3 to startup	the iW3 from power ON and standby

For best results, charge unit fully before use.

iPod Local Audio Mode

1 Connect iPad/iPhone/iPod using iPod	2 Press for iPod mode	3 In iPod mode, press	buttons
USB sync cable and USB port		on the iW3 to control your iPod music.

(iPod and aux-in play in parallel)

powerpower networknetwork setupsetup

off on

Press buttons to adjust volume.

Note: Use iPod mode for audio playback via iPod with USB cable and Aux-in.

AirPlay Wireless Audio Mode (visit pages 8-9 for Wi-Fi network configuration)

1 Verify that your iW3 speaker is successfully			2 Press	for AirPlay wireless mode	3 Launch iTunes or use your iPad, iPhone,
connected to your Wi-Fi network.					iPad touch. Verify iW3 and AirPlay source
(visit page 8 for connecting your iW3 speaker to your					device is on same Wi-Fi network.
Wi-Fi network)
		status network setup
	status network setup

AirPlayConnectedWireless AudioNot ConnectedMode

AirPlay only works with iPod touch, iPhone, iPad,

or iTunes (Mac or PC)

4 Select the iHome iW3 as your AirPlay audio speaker

Look for the AirPlay logo to select your speaker

5 Press	buttons on the iW3 or !	Note: for AirPlay streaming:
use your iTunes, iPad, iPhone, or iPod		iPad, iPhone, and iPod touch support
touch controls directly.
		point-to-point audio streaming to one
Adjust volume on the iW3 or wirelessly		AirPlay enabled speaker at a time.
control volume on your AirPlay source		iTunes supports point-to-multipoint audio
device.
Press	buttons to adjust volume.	streaming to up to three AirPlay enabled
		speakers (performance depends on both
		your Wi-Fi network and environment).

English 5