Mounting the Bar Speaker, Important Notes, Required Tools

Mounting the Bar Speaker

Important Notes

We recommend having this bar speaker professionally mounted.

The included spacers should be used at your discretion to extend the face of the bar speaker farther from the wall. These are typically used when mounting the bar speaker under a television, and the face of the bar speaker needs to be flush with the face of the television.

Required Tools

•Manual or Power Screwdriver

•Stud Finder

•Pencil

•Tape Measure

•Level

Getting Started

Use the Tape Measure to decide how high you’d like to hang the bar speaker on the wall.

The bar speaker must be hung within 6 feet of an AC power outlet for the attached AC Power Cord to reach.

Use the Stud Finder to locate 2 parallel wooden studs to screw the mounting brackets into.

Mark the wall at the center of the studs using the pencil.

Line the level up on both of your marks to make sure they are level. If they’re not, adjust the marks as needed to make them level.

After you’ve double checked your markings, drill through the top hole on both mounting brackets directly into the marks you’ve made on the wall.

If you are using the brackets only and no spacers, use the included short screws. If you are using any of the spacers or combination of the spacers, use the long screws.

Use the Level to level each of the hanging brackets, then drill the second screw into the bottom hole on both mounting brackets.

Slide the bar speaker onto the mounting brackets, and make sure there is a firm and stable connection before letting go of the bar speaker.

Finally, use the Level to confirm that the bar speaker is level.