7.Place the Spa Cover (11) over the Side Panels (1, 2) and the Spa Jet Unit (13). Be sure that the Spa
Cover is properly centered and that the straps on the Spa Cover line up with the straps extend- ing from the slots in the Side Panels (1, 2).
Snap each of the six latches on the Spa Cover (11) into the buckles on the straps extending from the slots in the Side Panels (1, 2).
7
11
13
1, 2
Latches and Buckles
USING THE HYDROTHERAPY SPA
The hydrotherapy spa is designed for up to four adults. The six water jets can be regulated to provide a relaxing massage to sooth away stress, and the strength of the water massage can be adjusted by the air control. The hydrotherapy spa holds 300 gallons of water and offers an automatic, programmable heating (70¡F to 104¡F) and filtration system.
The guidelines below explain how to properly use the hydrotherapy spa. Follow these guidelines to maintain the spa for your
PRIMING THE SPA JET UNIT
The water pump in the spa jet unit must be primed before you use the hydrotherapy spa the first time. You must also prime the pump before using the unit each time you
To prime the spa jet unit, remove the primer cap from the console. Fill the spa jet unit with at least 64 oz. of water. Replace
and tighten the primer cap. IMPOR- TANT: The spa jet
unit may be seriously damaged if the pump is not properly primed, or if the primer cap is not replaced and fully tightened.
PLUGGING IN THE HYDROTHERAPY SPA
Once the hydrotherapy spa is filled with enough water to cover the water jets and the pump has been primed, the power cord can be plugged in and the spa jet unit can be turned on. Note: The first time the power cord is plugged in, the spa jet unit will turn on automatically.
Grounded circuit capable of carrying 15 or more amps
Test and Reset
Buttons
GFCI
When connecting the power cord, plug the power cord directly into a grounded circuit capable of carrying 15 or more amps. No other appliance should be on the same circuit. Replace the power cord immediately if it becomes damaged.
The power cord is equipped with a Ground Fault Circuit Interrupter (GFCI), located at the end of the power cord. You should always test the GFCI before using the hydrotherapy spa.
First, turn on the hydrotherapy spa by pressing the power button on the console. Once the unit is run- ning, press the GFCI ÒtestÓ button. The hydrotherapy spa should shut off. Press the ÒresetÓ button. The hydrotherapy spa should resume normal operation. If the hydrotherapy spa continues to run after the ÒtestÓ button is pressed, then the GFCI is damaged. Do not use the hydrotherapy spa until the GFCI has been repaired or replaced by a qualified electrician.
10
