lines when handling the chemicals:
1.Always read and follow the directions on the label, unless directed otherwise.
2.Never mix different chemicals.
3.Keep all chemicals out of the reach of chil- dren and pets.
4.Do not exceed the recommended amountsÑfollow the directions on the label closely.
5.Keep all containers closed tightly when not in use.
6.Never add water to the chemicalsÑalways add the chemicals to the water as directed.
7.Always store chemicals in a cool, dry place.
MAINTAINING THE PROPER PH BALANCE
tation agents in the water will not be effective if the pH level is not properly maintained. Damage caused by improper pH levels is not covered under the warranty.
To maintain the proper pH level, you should test the pH of the water regularly. To test the water you can either purchase additional test strips or purchase a pH test kit at a pool and spa supply store. The pH reading should be between 7.2 and 7.8. If the level is too low, add a pH increaser (usually soda ash). If the level is too high, add a pH reducer (usually sodium bisulfate). Test the water again after five minutes. See the instructions with your test strips or pH test kit for addi- tional information about testing and adjusting the pH.
SANITIZING THE HYDROTHERAPY SPA
The pH factor is a measure of relative acidity or alka- linity in the water. It is measured on a scale of 1 to 14. Pure water has a value of 7, which is neutral. Any value above 7 is alkaline, and any value below 7 is acidic. You should maintain a slightly alkaline pH level, between 7.2 and 7.8, in the hydrotherapy spa.
Severe problems can occur when the pH balance is not maintained within this range. If the pH level exceeds 7.8, dissolved minerals can
Please refer to your local pool and spa supplier for information concerning which chemicals you should use in your area to sanitize the spa.
The most common sanitizing agent is a solid bromine concentrate. The amount required varies according to several factors, such as user load, temperature, water conditions, and so forth.
Proper water maintenance is a fairly complex process. We recommend that you contact your local pool and spa supplier for information on how you should best accomplish this.
TROUBLE-SHOOTING
Most problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, call our Customer Service Department
1.SYMPTOM: THE SPA WILL NOT OPERATE
a.Check the power cord. The power cord must be plugged into a grounded outlet (see PLUG- GING IN THE HYDROTHERAPY SPA on page 10).
b.Check to see if the GFCI breaker is tripped, or was not turned on. Reset the GFCI breaker.
2.SYMPTOM: THE CIRCUIT BREAKER OR GFCI BREAKER TRIPS WHILE THE SPA IS OPERATING
a.Reset the circuit breaker. If the circuit breaker trips again, contact a qualified electrician for service.
3.SYMPTOM: THE PUMP HUMS
a.The filter may be dirty or damaged. Remove
the filter housing from the spa jet unit and clean or replace the filter.
b. The pump may have a foreign object stuck in the impeller. Contact our customer service department.
c. The pump may have a loose wire connection. Contact our customer service department.
4.SYMPTOM: THE PUMP HUMS BUT DOES NOT ROTATE
a.The pump may be jammed. Contact our cus- tomer service department.
5.SYMPTOM: THE PUMP IS NOISY WHILE OPERATING
a.There may be debris in the pump. Contact our customer service department.
14
