4.Remove the power cord from the Spa Jet Unit (13).
With the help of a second person, place the Spa Jet Unit (13) over the Side Panel (1) and the section of the Inflatable Spa Liner (9) which does not have the cushion. Be extremely careful not to tear the
Inflatable Spa Liner (9) as you slide the Spa Jet Unit into place.
5.Before you fill the hydrotherapy spa, be sure that it is in the position you want, and that it can be easily serviced, if needed. Once the hydrotherapy spa is filled with water, it will need to be drained to be moved.
Using a garden hose or other clean water source, begin filling the hydrotherapy spa, until the jet and filter openings on the Spa Jet Unit (13) are covered with water. Do not fill the RENEW 800 more than 20Ó deep with water.
After the RENEW 800 is full, you must prime the Spa Jet Unit (13) before using the hydrotherapy spa (see PRIMING THE SPA JET UNIT on page 10).
6.Insert the Support Ball (4) into the mesh pocket on the underside of the Spa Cover (11).
See inset drawing A. Insert the inflation tube into the hole in the Support Ball (4). Inflate the Support Ball.
See inset drawing B. When the Support Ball (4) is inflated, remove the inflation tube from the Support Ball and insert the ball plug through the mesh into the Support Ball. The head of the ball plug will hold the Support Ball in place.
Note: The Support Ball (4) is not a toy.
9
4 |
| |
| 13 | |
| Power | |
| Cord | |
| 9 | |
| 1 | |
5 | 9 | |
| ||
| 13 | |
6 | Mesh Pocket | |
11 | ||
| 4 | |
A | B | |
Inflation | Ball | |
Plug | ||
Tube | ||
4 | ||
| ||
| 4 |
