Image IMHS80081 manual Maintenance

Models: IMHS80081

1 17
Download 17 pages 41.68 Kb
Page 13
Image 13
MAINTENANCE

ment by removing the filter cover and the two filter cover screws and then pulling the filter from the spa jet unit.

The spa jet unit features an automatic filter cycle and freeze protection. If the spa jet unit has not been oper- ated for three hours, the pump will begin circulating the water for twenty minutes to filter any impurities. Also, if the water temperature falls below 40¡F, the pump will begin circulating and heating the water to prevent the water from freezing.

DRAINING THE HYDROTHERAPY SPA

To drain the hydrotherapy spa, you must use a garden

hose to siphon the water. Place one end of the hose in the spa and hold it in front of a hydrotherapy jet until there is a flow of water coming out of the hose. Turn off the spa unit and unplug the power cord. The unit will be damaged if it is run without water cir- culating. Be sure the end of the hose in the spa is on the floor of the spa.

DRAINING THE PUMP

After the hydrotherapy spa is drained (see DRAINING THE HYDROTHERAPY SPA above), the pump in the spa jet unit should also be drained if the spa will be stored for more than thirty days, or if it may be exposed to freezing temperatures.

To drain the pump,

 

remove the spa jet unit

 

from the side panels.

Pump

Be careful not to tear

 

the inflatable spa

 

liner. Locate the pump

 

inside the spa jet unit.

 

Remove the drain plug

 

from the pump. Tip the

Drain Plug

spa jet unit slightly,

 

until all the water has drained from the pump. Replace the drain plug.

MAINTENANCE

CLEANING THE INFLATABLE SPA LINER

The liner should be cleaned with a mild soap solution. Do not use solvents. The liner should always be clean and dry before being moved or stored.

CHECKING AND CLEANING THE FILTER

The filter should be checked periodically for build-up of dirt and oil. If the filter needs to be cleaned, follow the steps below:

1.Turn off the power.

2.Remove the two screws and cover from the spa jet. Then pull the filter out of the unit.

3.Check the filter for any dirt or debris. If the fil- ter needs to be cleaned, rinse the filter with a hose. If the filter still is dirty, you will need to soak it in a cleaning solution which can be obtained from a pool and spa supply store.

4.Inspect the filter for damage. Replace the fil- ter if there are any signs of damage.

5.Re-insert the cleaned filter and re-attach the two screws and cover to the spa jet unit.

MAINTAINING THE SPA COVER

The spa cover should be cleaned monthly. Remove the support ball from the spa cover, then hang the spa cover over a clothes line and spray it with a hose. Leave the cover on the clothes line until it is fully dry.

WINTER USE AND CARE

The hydrotherapy spa is designed for year-round use. If you decide to store the spa for the winter, store it in a warm, dry location. (See DRAINING THE HYDROTHERAPY SPA and DRAINING THE PUMP on this page.)

WATER CHEMISTRY

The hydrotherapy spa comes with a starter chemical pack for maintaining the water in the spa. (See TEST- ING AND TREATING THE WATER on page 11.) Additional chemicals can be purchased at a pool and spa supply store.

CAUTION: The chemicals used to maintain the pH balance of the water and to sanitize the water can be dangerous. Always follow these basic guide-

13

Page 13
Image 13
Image IMHS80081 manual Maintenance