Assembly
Before beginning assembly, carefully read the following information and instructions:
•Place all parts in a cleared area and remove the packing materials from the spa shell. Do not dis- pose of the packing materials until assembly is completed and the spa is operating.
•During assembly, make sure that all parts are oriented as shown in the drawings.
•Read each assembly step before you begin.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
ASSEMBLY REQUIRES THE FOLLOWING TOOLS (not included):
•One (1) phillips screwdriver 
•You may also need a small amount of soapy water.
A wire connector is provided on the electronics pack of the spa to connect a minimum No. 6 AWG (13.03 mm2) solid copper conductor between the spa and any metal equipment, electrical enclosure made of metal, metal water pipes, or conduit within five feet of the spa.
1.Before beginning assembly, make sure that you have read and understand the information in the box above and on the previous two pages.
Remove the four indicated #10 x 2” Sheet Metal Screws (7). Remove the Access Panel (2) by sliding it down and then pulling the bottom away from the spa. Be careful not to damage the spa shell.
2.Locate the drain hose inside of the spa. Close the valve knob on top of the drain hose. Make sure that the cap is fully tightened onto the end of the drain hose.
Locate the two indicated gate valves inside of the spa. Make sure that the gate valves are open and that the locking clips are snapped onto the stems of the gate valves. In addition, make sure that the four indicated collars are tight.
See step 1.
1 | Spa Shell |
|
|
|
|
|
|
| |
7 |
|
|
|
|
| 2 |
|
|
|
| 7 |
|
|
|
2 |
|
|
|
|
|
| Gate |
|
|
|
| Valve |
|
|
|
| Collars |
|
|
| Collar |
| Collar |
|
| Locking |
|
|
|
| Clip |
|
|
|
|
| Drain | Valve | Cap |
Stem | Hose | Knob |
| |
|
|
| ||
| Gate Valve |
|
|
|
8
