Image IMTL11997 Trouble-Shooting, Problem The power turns off during use, Solution, Power cord

TROUBLE-SHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department toll-

free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor

is plugged into a properly grounded outlet (see page 8). Use only a single-outlet surge suppressor that meets all of the specifications described on page 8. Important: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

d. Check the on/off switch located on the treadmill near the power cord. The switch must be in the on position.

PROBLEM: The power turns off during use

c
Tripped	Reset
d	On
	Position

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in.

c. Unplug the power cord, wait for five minutes, and then plug the power cord back in.

d. Remove the key from the console. Reinsert the key fully into the console.

e. Make sure that the on/off switch is in the on position.

f. If the treadmill still will not run, please call our Customer Service Department, toll-free.

PROBLEM: The displays of the console do not function properly
SOLUTION:	a. Remove the key from the console and			unplug the
	power cord.	Carefully tip the treadmill down as shown
	in drawing a. Remove the Screws (39, 83) from the
	hood. Raise the Uprights (69) and carefully remove
	the hood.
	Locate the Reed Switch (10) and the Magnet (7) on
	the left side of the Pulley (8). Turn the Pulley until the
	Magnet is aligned with the Reed Switch.			Make sure
	that the gap between the Magnet and the Reed
	Switch is about 1/8”.		If necessary, loosen the Screw
	(80) and move the Reed Switch slightly. Retighten the
	Screw. Re-attach the hood, and run the treadmill for a
	few minutes to check for a correct speed reading.

a
	39
69	83
1/8”	8
80
10	7
Top
View

23