10.Lower the Uprights (31, 36).
See the inset drawing. Position the Uprights (31, 36) so that the treadmill Frame (74) is centered between the Uprights.
Firmly tighten the Frame Bolts (32) and then the Upright Bolts (40) on each side of the treadmill.
Do not overtighten the Frame Bolts.
11.Attach the ground wire on the Upright Wire (28) to the indicated hole in the Base (48) with a Silver Ground Screw (27).
Press the indicated grommet into the Right Upright (36).
Raise the Uprights (31, 36).
10 | Side View | 32 |
| ||
|
| 40 |
| 31, 36 |
|
| 74 |
|
| View from Above |
|
31 | 74 | 36 |
11 |
|
|
Grommet
36
28
48 
Ground
Wire
27
12.Attach the Latch Housing (30) to the Left Upright (31) with two 3/4" Screws (2). Make sure that the large hole in the Latch Housing is on the side shown. Do not overtighten the Screws.
Remove the knob from the pin. Make sure that the collar and the spring are on the pin as shown. Insert the pin into the Latch Housing (30), and tighten the knob back onto the pin.
12
30
Knob 
31
2 
Pin
Spring
Collar
13.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see page 21). To protect the floor or carpet, place a mat under the treadmill.
10
