7.Route the Upright Wire (28) through one of the Handrails (18) as shown, and remove the wire tie from the Upright Wire.
Attach the Handrail (18) to the Right Upright (36) with two Handrail Bolts (20) and two Handrail Star Washers (19). Be careful not to pinch the
Upright Wire (28).
Attach the other Handrail (18) to the Left Upright (31) with two Handrail Bolts (20) and two Handrail Star Washers (19).
8.While another person holds the Console Base (26) near the right Handrail (18), attach the ground wire on the Console Base to the right Handrail with a Silver Ground Screw (27).
Connect the wire harness on the Console Base
(26)to the Upright Wire (28) as shown in the inset drawing. Important: If the connectors are oriented correctly, they will slide together easily and snap into place. If the connectors are not oriented correctly, the console may be damaged when the power is turned on.
9.Insert the wires into the Console Base (26) as you set the Console Base on the Handrails. Be careful not to pinch the wires. Next, thread two Console Bolts (22) with 1/4" Star Washers (21) into the Handrails and the Console Base; do not tighten the Console Bolts yet.
Attach the Console Base (26) to the Handrails (18) with four 3/4" Screws (2). Then, tighten the two Console Bolts (22).
7 |
|
20 |
|
19 | Wire Tie |
28 | |
31 | 20 |
| |
18 | 19 |
18 |
|
| 36 |
8 | 26 |
| |
27 | Ground |
Wire | Wire |
Harness |
|
28 |
|
| 18 |
| 28 |
9 |
|
| 26 | Front View |
|
| |
18 |
| 18 |
|
|
| 21 | 2 |
2 |
| |
22 | 21 | |
|
| |
|
| 22 |
9
