21
T1 Port Verification
By placing a physical loopback connection on the T1 port, a valid signal can be
detected by each individual T1 port to verify its operation. Without the fiber looped,
the ALARM
LED
for the looped T1 port will show RED/GREEN indicating there is a
problem at the far end of the fiber transport (In this case the far end unit is missing)
and the STAT LED is RED because the fiber is in LOS. With the fiber looped, the T1
port will only show a normal GREEN STAT LED.
10/100BaseT Ethernet Mating Connector Pinout
The following table lists the pin configuration for the standard RJ-45 Ethernet
connector.
Pin Signal
1 Transmit +
2 Transmit -
3 Receive +
4 None
5 None
6 Receive -
7 None
8 None
NOTE
MDI/MDIX AutoCross function will automati cally transpose the Transmit and
Receive lines if required.
Pin 1