STEP 12 (See Diagram 12)
A.) | Attach end of the 357” Leg Press Cable (#39) to the bracket on the Left Seat Support |
| (#8). Secure the Cable to the bracket with one M10 x 1” Allen Bolt (#81), two Ø ¾” |
| Washers (#99), and one M10 Aircraft Nut (#96). |
B.) | Draw the Cable to the upper open bracket on the Leg Press Frame. Attach a Pulley to |
| the bracket. Secure it with one M10 x 1 3/4” Allen Bolt (#82), two ∅ ¾” Washers (#99), |
| and one M10 Aircraft Nut (#96). |
C.) | Draw the Cable around the Pulley then to the open bracket on the Left Seat Support |
| (#8). Attach a Pulley to the opening. Secure it with one M10 x 1 ¾” Allen Bolt (#82), two |
| Ø ¾” Washers (#99), and one M10 Aircraft Nut (#96). |
D.) Draw the Cable around the Pulley then back to the lower open bracket on the Leg Press | |
| Frame. Repeat Procedure B above to install a Pulley. |
E.) | Draw the Cable around the Pulley then to the lower opening on the Left Seat Support. |
| Install another Pulley and secure it with one M10 x 2 3/8” Allen Bolt (#83), two Pulley |
| Bushings (#55), and one M10 Aircraft Nut (#96). |
F.) | Draw the Cable underneath the Pulley then through the bottom of Left Vertical Beam to |
| the first open bracket on the Left Base Frame. |
G.) Install a Pulley with one M10 x 1 ¾” Allen Bolt (#82), two ∅ ¾” Washers (#99), and one
| M10 Aircraft Nut (#96). |
H.) | Pull the Cable upward to the front opening on the Vertical Press Frame (#20). Install a |
| Pulley with one M10 x 5 ¾” Allen Bolt (#86), two Ø ¾” Washers (#99), and one M10 |
| Aircraft Nut (#96). |
I.) | Draw the Cable around the Pulley then downward to the second open bracket on the |
| Left Base Frame. Repeat Procedure G above to install a Pulley. |
J.) | Pull the Cable upward to the back opening on the Vertical Press Frame. Repeat |
| Procedure H above to install a Pulley. |
K.) | Draw the Cable around the Pulley then downward to the third open bracket (angled) on |
| the Left Base Frame. Repeat Procedure G above to install a Pulley. |
L.) | Pull the Cable upward and connect to the Short Chain (#77) with a |
| After completing the entire Cable installations, check the tightness of the Cables, if the |
| Cables are too loose, shorten the Chain. If the Cables are too tight, lengthen the Chain. |
M.) Connect the Chain to the 61”Vertical Press Cable (#40) with a M10 x 1” Allen Bolt (#81), two Ø ¾” Washers (#99), and one M10 Aircraft Nut (#96).
N.) Draw the Cable to the bracket on the top of Upper Frame (#6). Install two Small Pulleys (#57) to the bracket with two 2 3/8”
O.) Draw the Cable over the Small Pulleys then downward. Securely threaded it through the Weight Selector Pin (#46) into the Selector Rod (#29).
P.) Use the Nut on the Bolt at the end of the Cable to securely tighten the Bolt to the Selector Rod.
20
