Impex MP-3105 manual See Diagram 7 & Cable Loop Diagram

STEP 7 (See Diagram 7 & Cable Loop Diagram)

A.) Attach one 123” Cable (#37) to the lower opening on the Rear Vertical Beam (#10). Attach a Small Pulley (#45) to the opening. Secure it with a M10 x 2 ¾” Allen Bolt (#76), two Ø 1” x 5/8” Pulley Bushings (#41), and one M10 Aircraft Nut (#89).

B.) Draw the Cable underneath the Pulley to the open bracket on the Weight Glide Post Base (#11). Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#73), two ∅ ¾” Washers (#87), and one M10 Aircraft Nut (#89).

C.) Draw the Cable around the Pulley then upward to the Double Floating Pulley Bracket (#23) previously installed in Step-5. Install a Pulley.

D.) Draw the Cable around the Pulley then downward to the open bracket on the back of Rear Vertical Beam (#10). Install a Pulley then draw the Cable upward to the Single Floating Pulley Bracket (#24) installed in Step-6. Secure the end of the Cable to the bracket with one M10 x 1” Allen Bolt (#72), two ∅ ¾” Washers (#87), and one M10 Aircraft Nut (#89).

E.) Connect the V Bar (#35) to the Cable with a Long Chain (#46) using two Hooks (#48).

F.) Check the tension of the Cables. If the Cables are too loose, adjust the tension by moving up the Pulley on the Double Floating Pulley Bracket (#23). If the Tension is too tight, then move down the Pulley.

18