Impex MP 1100 manual See Diagram 7 & Cable Loop Diagram

STEP 7 (See Diagram 7 & Cable Loop Diagram)

A.)	Attach the 144” Lower Cable (#59) to the opening on the bottom of the Leg
	Developer (#9).
B.)	Attach a Pulley (#41) to the opening. Secure it with one M10 x 2 ½” Allen Bolt
	(#64), two ∅ 7/8” Pulley Bushings (#35), and one M10 Aircraft Nut (#81).
C.)	Draw the Cable underneath the Pulley towards the back of the machine through
	the opening on the bottom of the Main Base Frame (#1) to an open bracket.
D.)	Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#65),
	two Ø ¾” Washers (#77), and one M10 Aircraft Nut (#81).
E.)	Draw the Cable underneath the Pulley towards the back of the machine to the
	Pulley Bracket (#18) underneath the Main Base Frame.
F.)	Attach a Pulley to the bracket. Secure it with one L-shaped Bracket (#23), one
	M10 x 2” Allen Bolt (#66), two ∅ ¾” Washers (#77), and one M10 Aircraft Nut
	(#81).
G.)	Pull the Cable upward to the Angled Double Floating Pulley Brackets (#15)
	previously installed in Step 6. Repeat Step D to install another Pulley.
H.)	Draw the Cable around the Pulley then pull downward to the open bracket on the
	Main Base Frame. Repeat Step D to install another Pulley.
I.)	Draw the Cable around the Pulley then pull upward to the Double Floating Pulley
	Bracket (#14) previously installed in Step-5. Repeat Step D to install a Pulley.
J.)	Draw the Cable around the Pulley then pull downward to the bracket on the rear
	of Main Base Frame. Attach the Cable to a 6-Joint Chain (#25) using a C-clip
	(#28). Secure the other end of the Chain to the bracket with a M10 x 1” Allen
	Bolt (#72), two ∅ ¾” Washers (#77) and one M10 Aircraft Nut (#81).
K.)	Use the length of the Chain to adjust the tension of the Cable Loop System. If
	the Cables are too loose, shorten the Chain.
L.)	Attach the 15-Joint Chain (#27) to the end of the Cable by using a C-clip. Attach
	the Arm Curl Handle (#12) to the Chain by using another C-clip. Replace Arm
	Curl Handle with the Ankle Strap (#82) for various Leg exercises. Adjust the
	length of Chain to obtain the desired exercise. Remove the Arm Curl Handle and
	Ankle Strap when using the Leg Developer.
M.)	Lubricate the two Guide Rods with WD-40 or light oil. This will minimize the
	friction on the Rods so the weight plates can slide up and down on the rods more
	freely.

15