ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches. NOTE: It is strongly recommended this machine to be assembled by two or more people to avoid possible injury.
STEP 1 (See Diagram 1)
A.) | Slide two Ø2 ½” Round Rubber Bumpers (#43) onto the Guide Rods (#7). Insert |
| the two Guide Rods into the holes on the Rear Stabilizer (#8). Secure each Guide |
| Rod with one M10 x 1” Allen Bolt (#72) and ∅ ¾” Washer (#77) from the bottom. |
B.) | Attach the rear of Main Base Frame (#1) to the Rear Stabilizer. Secure them with |
| two M10 x 2 ¾” Carriage Bolts (#62), one 4 3/8” x 2” Bracket (#20), two Ø ¾” |
| Washers (#77), and two M10 Aircraft Nuts (#81). Do not tighten the nuts and bolts |
| yet. |
C.) Attach the Front Base Frame (#19) to the Main Base Frame (#1). Secure them
| with one M10 x 3” Allen Bolt (#74), one 4” x 2” Bracket (#29), two Ø ¾” Washers |
| (#77), and one M10 Aircraft Nut (#81) to the top hole. Secure the bottom hole with |
| one M10 x 2 ½” Allen Bolt (#64) and ∅ ¾” Washer (#77) from the back. |
D.) | Attach the Front Stabilizer (#30) to the Front Base Frame. Secure them with two |
| M10 x 2 ¾” Carriage Bolts (#62), one 4 ¾” x 2” Bracket (#22), two Ø ¾” Washers |
| (#77), and two M10 Aircraft Nuts (#81). |
E.) | Place the Vertical Frame (#2) onto the Main Base Frame. Secure them with two |
| M10 x 3 ½” Carriage Bolts (#63), one Pulley Bracket (#18), two Ø ¾” Washers |
| (#77), and two M10 Aircraft Nuts (#81). Securely tighten all nuts and bolts |
| previously installed. |
6
