STEP 5 (See Diagram 5 & Cable Loop Diagram)
A.) Attach the 182” Upper Cable (#41) to the front opening on the Upper Frame (#3).
NOTE: The Ball Stopper on the Cable needs to be underneath the Frame. B.) Attach a Pulley (#26) to the opening. Secure it with one M10 x 2 ½” Allen Bolt
(#53), two Ø 7/8” Bushings (#23), and one M10 Aircraft Nut (#56).
C.) Draw the Cable towards the back of the machine to another opening on the Upper Frame. Repeat Procedure B above to install a Pulley.
D.) Draw the Cable around the Pulley then pull back to the opening on the Front Press (#4). Attach a Pulley to the opening. Secure it with one M10 x 6 1/8” Allen Bolt (#50), two Ø ¾” Washers (#59), and one M10 Aircraft Nut (#56).
E.) Draw the Cable around the Pulley then to the opening on the Vertical Frame (#2). Repeat Procedure B to install a Pulley.
F.) Draw the Cable around the Pulley then back to the lower opening on the Front Press. Repeat Procedure D to install a Pulley.
G.) Draw the Cable around the Pulley then back to the lower opening on the Vertical
| Frame. Repeat Procedure B to install a Pulley. |
H.) | Draw the Cable over the Pulley and pull the Cable downwards. Attach a Pulley to |
| the upper holes on the two Double Floating Pulley Brackets (#11). |
I.) | Attach a Pulley to the Brackets. Secure it with one M10 x 1 ¾” Allen Bolt (#54), two |
| Ø ¾” Washers (#59), and one M10 Aircraft Nut (#56). Let the Brackets hanging for |
| now. |
J.) | Draw the Cable around the Pulley then pull upwards to the opening on the rear |
| Upper Frame. Repeat Procedure B to install a Pulley. |
K.) | Pull the Cable downwards between the two Guide Rods to the Selector Rod (#9). |
| Securely thread the bolt at the end of the Cable into the Selector Rod. |
L.) | Connect Lat Bat (#8) to the Cable with one Chain (#45) and two Hooks (#43). |
14
