Indesit HI 20.B IB, HI 22 C.B IB, HI 22 C.B IX IB, HI 20.B IX IB manual Electrical connections

Electrical connections

The cooker must be connected to the mains electricity supply. It is designed to operate with alternating current at the voltage and frequency indicated on the data plate (see the following page).

The hob is connected to the cooker using a special connector.

BUILT-IN HOB

Only on

certain models

WHITE RED YELLOW BLUE GREE N

BUILT-IN COOKER

Fitting the power supply cable

1. Open the terminal board by inserting a screwdriver into the side tabs of the cover. Use the screwdriver as a lever by pushing it down to open the cover (see diagram).

		2. Install the power
		supply cable by
		loosening the cable
		clamp screw and the
		three wire contact
		screws L-N- . Connect
		the wires to the
		corresponding
N	L	terminals: the Blue wire
		to the terminal marked
		(N), the Brown wire to
the terminal marked (L) and the Yellow Green wire
to the terminal marked (see diagram).

3. Secure the cable by fastening the clamp screw.

GB

4. Close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load indicated on the data plate (see side).

The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3 mm installed between the appliance and the mains, suitable for the load indicated and complying with current electrical regulations (the earthing wire must not be interrupted by the circuit-breaker). The supply cable must not come into contact with surfaces with temperatures higher than 50°C.

!The installer must ensure that the correct electrical connection has been made and that it is compliant with safety regulations.

Before connecting to the power supply, make sure that:

•The appliance is earthed and the plug is compliant with the law.

•The socket can withstand the maximum power of the appliance, which is indicated on the data plate (see below).

•The voltage must be in the range between the values indicated on the data plate (see below).

•The socket is compatible with the plug of the appliance. If the socket is incompatible with the plug, ask an authorised technician to replace it. Do not use extension cords or multiple sockets.

!Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible.

!The cable must not be bent or compressed.

!The cable must be checked regularly and replaced by authorised technicians only (see Assistance).

!The manufacturer declines any liability should these safety measures not be observed.

3