Indesit HI 50.A IX, HIN 5S IX, HI 500.B, HIN 550 IX Connecting the supply cable to the mains

Connecting the supply cable to the mains

GB

Install a standardised plug corresponding to the load indicated on the data plate (see side).

The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3 mm installed between the appliance and the mains, suitable for the load indicated and complying with current electrical regulations (the earthing wire must not be interrupted by the circuit-breaker). The supply cable must not come into contact with surfaces with temperatures higher than 50°C.

￿The installer must ensure that the correct electrical connection has been made and that it is compliant with safety regulations.

Before connecting to the power supply, make sure that:

•The appliance is earthed and the plug is compliant with the law.

•The socket can withstand the maximum power of the appliance, which is indicated on the data plate (see below).

•The voltage must be in the range between the values indicated on the data plate (see below).

•The socket is compatible with the plug of the appliance. If the socket is incompatible with the plug, ask an authorised technician to replace it. Do not use extension cords or multiple sockets.

￿Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible.

￿The cable must not be bent or compressed.

￿The cable must be checked regularly and replaced by authorised technicians only (see Assistance).

￿The manufacturer declines any liability should these safety measures not be observed.

DATA PLATE
Dimensions	width 43.5 cm
	height 32 cm
	depth 40 cm
Volume	lt. 56
Electrical	voltage: 230V/400V~ 3N 50/60Hz
connections	maximum power absorbed 8450W
	Directive 2002/40/EC on the label
	of electric ovens.
	Standard EN 50304
ENERGY LABEL	Energy consumption for Forced
	convection heating mode:
	Multi-cooking
	Declared energy consumption for
	Natural convection Class heating
	mode:	Convection

This appliance conforms to the following European Economic Community directives:

2006/95/EEC of 12/12/06 (Low Voltage) and subsequent amendments;

- 2004/108/EEC of 15/12/04 (Electromagnetic Compatibility) and subsequent amendments;

- 93/68/EEC of 22/07/93 and subsequent amendments.

-2002/96/EC and subsequent amendments.

4