Indesit I6VV2A manual Installation, Positioning and levelling, Electrical connection, Levelling

Installation

GB	! Before operating your new appliance please read
	this instruction booklet carefully. It contains important
	information concerning the safe installation and
	operation of the appliance.
	! Please keep these operating instructions for future
	reference. Make sure that the instructions are kept with
	the appliance if it is sold, given away or moved.
	! The appliance must be installed by a qualified
	professional according to the instructions provided.
	! Any necessary adjustment or maintenance must be
	performed after the appliance has been disconnected
	from the electricity supply.
	Positioning and levelling
	! It is possible to install the appliance alongside
	cupboards whose height does not exceed that of the
	hob surface.
	! Make sure that the wall in contact with the back of
	the appliance is made from a non-flammable, heat-
	resistant material (T 90°C).

To install the appliance correctly:

•Place it in the kitchen, dining room or the bed-sit (not in the bathroom).

•If the top of the hob is higher than the cupboards, the appliance must be installed at least 200 mm away from them.

The legs* provided with the appliance fit into the slots on the underside of the base of the cooker.

Electrical connection

Electric cookers come without a power supply cable. The cooker is designed to operate on an electricity supply which conforms to the electrical data shown on the Rating Plate. The cooker can be connected to the mains only after removing the back panel of the cooker itself with a screwdriver.

!the following installation procedure must be carried out by a qualified electrician. The electrical installation must comply with the IEE Regulations, Building & local By-Lays.

1. Open the terminal board by inserting a screwdriver into the side tabs of the cover. Use the screwdriver as a lever by pushing it down to open the cover (see

diagram).

2. Loosen the cable clamp screw and remove it,

Min. 420mm.

HOOD

Min. 600mm.

Min. 420mm.

min. 650 mm. with hood min. 700 mm. without hood

•If the cooker is installed underneath a wall cabinet, there must be a minimum distance of 420 mm between this cabinet and the top of the hob. This distance should be increased to 700 mm

if the wall cabinets are flammable (see figure).

using a screwdriver as a lever (see figure).

3. Remove the wire contact screws L-N- , then fasten the wires under the screw heads, respecting the colour code: Black/Blue (N), Red/ Brown (L) and Bare Wire/ Yellow-Green ().

• Do not position

blinds behind the cooker or less than 200 mm away from its sides.

•Any hoods must be installed according to the instructions listed in the relevant operating manual.

Levelling

If it is necessary to level the appliance, screw the adjustable feet* into the places provided on each corner of the base of the cooker (see figure).

• Once the connections

have been made, tighten all the terminal screws fully.

•Fasten the supply cable in place with the clamp and close the cover of the terminal board.

8