Indesit I6VV2A manual Connecting the supply cable to the mains, Safety Chain

Connecting the supply cable to the mains

WARNINGS: THIS APPLIANCE MUST BE EARTHED.

!The cooker must be connected to the mains by a switched (double pole) cooker outlet correctly fused with a capacity appropriate to that shown on the cooker Rating Plate. All electrical wiring from the consumer unit to the cooker, via the switched double pole cooker outlet, must be of an acceptable type and current rating as above.

!the supply cable must be positioned so that it never reaches at any point a temperature 50°C higher than the room temperature. The cable must be routed away from the rear vents.

HOT PARTS

Safety Chain

! In order to prevent accidental tipping of the appliance, for example by a child clim- bing onto the oven door, the supplied safety chain MUST be installed!

The cooker is fitted with a safety chain to be fixed by means of a screw (not supplied with the cooker) to the wall behind the appliance, at the same height as the chain is attached to the appliance.

Choose the screw and the screw anchor according to the type of material of the wall behind the applian- ce. If the head of the screw has a diameter smaller than 9mm, a washer should be used. Concrete wall requires the screw of at least 8mm of diameter, and 60mm of length.

Ensure that the chain is fixed to the rear wall of the cooker and to the wall, as shown in figure, so that after installation it is tensioned and parallel to the

ground level.

TECHNICAL DATA
Oven dimensions	32x43,5x40 cm
(HxWxD)
Volume	58 l
Useful	width 42 cm
measurements
	depth 44 cm
relating to the oven
	height 8,5 cm
compartment
Power supply
voltage and	see data plate
frequency
Electric hob
Front left	1700 W
Back left	1200 W
Back right	2100 W
Front right	1200 W
Maximum absorption
of the electric hob	6200 W
	Directive 2002/40/EC on the
	label of electric ovens.
	Standard EN 50304
ENERGY LABEL	Energy consumption for Natural
	convection – heating mode:
	Traditional mode;
	Declared energy consumption
	for Forced convection Class –
	heating mode: Fan assisted
	EC Directives: 2006/95/EC
	dated 12/12/06 (Low Voltage)
	and subsequent amendments -
	04/108/EC dated 15/12/04
	(Electromagnetic Compatibility)
	and subsequent amendments -
	93/68/EEC dated 22/07/93 and
	subsequent amendments -
	2002/96/EC.

Data plate, is located inside the flap or, after the oven compartment has been opened, on the left-hand wall inside the oven.

GB

9