Installation
Prior to installation, ensure that the local distribution GB conditions (nature of the gas and gas pressure) and
the adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the data badge which is fitted on the back panel. This appliance is not designed to be connected to a combustion products evacuation device. It must be installed and connected in accordance with current installation regulations. particular attention should be given to the relevant requirements regarding ventilation.
MODEL NUMBERS KD6G25SAIR,
D6G25SXIR, KD6G25SWIR
LOCATION
The cooker may be located in a kitchen, kitchen/ diner or a
PROVISION FOR VENTILATION
The room containing the cooker should have an air supply in accordance with BS 5440: Part 2.
Category II2H3+ (GB)
These models are set to burn NATURAL GAS (G20) at 20 mbar but can be converted for use on BUTANE (G30) at
GAS SAFETY (INSTALLATION & USE) REGULATIONS
It is the law that all gas appliances are installed by competent persons in accordance with the current edition of the above regulations. It is in your interest and that of safety to ensure compliance with the law. In the UK, CORGI registered installers work to safe standards of practice. The cooker must also be installed in accordance with BS 6172. Failure to install the cooker correctly could invalidate the warranty liability claims and could lead to prosecution.
The room must have an opening window or equivalent; some rooms may also require a permanent vent. If the room has a volume between 5 and 10m3, it will require an air vent of 50cm2 effective area unless it has a door which opens directly to outside. If the room has a volume of less than 5m3, it will require an air vent of 100cm2 effective area. If there are other fuel burning appliances in the same room, BS 5440: Part 2 should be consulted to determine air vent requirements.
TECHNICAL DATA
Gas connection | Rp ½ (½" BSP female) |
Pressure test point | Front left hotplate injector |
Gas rate adjustment | None |
Aeration adjustment | None |
Electrical connection | Flexible cord fitted with a |
| 3 pin 13 amp plug |
| 230/240V a.c. 50Hz. |
| 13A fuse. |
| G20 at 20mbar | G30 at |
| ||
| G31 at 37mbar |
| |||
|
|
|
| ||
|
|
|
|
|
|
Burner | Heat Input | Injector | Heat Input | Injector |
|
|
|
|
|
|
|
Hotplate | 3.0 kW | 116 | 3.0 kW (220g/h) | 86 |
|
Front Left |
| ||||
|
|
|
|
| |
|
|
|
|
|
|
Hotplate | 2.0 kW | 103 | 2.0 kW (145g/h) | 70 |
|
Rear Left and Rear Right |
| ||||
|
|
|
|
| |
|
|
|
|
|
|
Hotplate | 1.1 kW | 79 | 1.0 kW (70g/h) | 50 |
|
Front Right |
| ||||
|
|
|
|
| |
|
|
|
|
|
|
Grill | 2.8 kW | 129 | 2.8 kW (200g/h) | 85 |
|
|
|
|
|
|
|
Main Oven | 2.5 kW | 115 | 2.3 kW (165g/h) | 72 |
|
|
|
|
|
|
|
Top Oven | 1.9 kW | 100 | 1.9 kW (135g/h) | 65 |
|
|
|
|
|
|
|
|
|
|
|
|
|
16
