InFocus LPTM425z warranty Usage Guidelines, If You Need Assistance

Usage Guidelines

•Do not look directly into the projection lens when the projector is turned on. The bright light may harm your eyes.

•Do not block the grills on the projector. Restricting the air flow can cause it to overheat and turn off. If this happens, you must wait a minute before attempting to turn it back on.

•Handle the projector as you would any product with glass components. Be especially careful not to drop it.

•Avoid leaving the projector in direct sunlight or extreme cold for extended periods of time. If this happens, allow it to reach room temperature before use.

•This projector is not intended for use in mainframe computer rooms as defined in the Standard for the Protection of Elec- tronic Computer/Data Processing Equipment, ANSI/NFPA 75.

•Transport the projector in a vendor-approved hard or soft case. Part numbers for these cases are listed on page 48.

If You Need Assistance

The first place to look for help is in this manual. Be sure to check the guidelines in “Troubleshooting” on page 40. Or, check the Service and Support section of our website at

http://www.infocus.com/service.

If those sources don’t answer your question, call your InFocus dealer. You can also call InFocus Customer Service directly at 1-800-799-9911. Call between 6 a.m. and 6 p.m. PST, Monday through Friday. Service is available in North America after hours and on weekends for a fee at 1-888-592-6800.

In Europe, call InFocus in The Netherlands at

(31)35-6474010between 8 a.m. and 6 p.m. Central European Time.

In Asia, call (65) 332-0659between 9:30 a.m. and 5:30 p.m.

Or, send us an e-mail at techsupport@infocus.com

Our World Wide Web address is http://www.infocus.com.

5