InFocus PRJ-WALLKIT-13 Assembling Wall Plate to Brackets, Concrete or Concrete Block

PRJ-WALLKIT-13 Installation Instructions

ASSEMBLY AND INSTALLATION

The PRJ-WALLKIT-13 short throw projector mount is designed to be mounted to solid concrete, hollow concrete block, 2" x 4" wood studs (16" on center), or steel studs (16" on center).

Assembling Wall Plate to Brackets

IMPORTANT ! : This step must be taken for BOTH single AND dual stud installations!

1.Attach wall plate (B) to two dual stud brackets (G) using four 5/16" lock nuts (HF). (See Figure 1)

(G)

1 (HF) x 4

(B)

Figure 1

NOTE: Proceed to the Concrete or Concrete Block, Wood Studs or Steel Studs section, as appropriate for installation.

Concrete or Concrete Block

1.Using wall plate/bracket assembly, mark four mounting holes (dual stud), or two mounting holes (single stud) in wall plate. (See Figure 2)

2.Drill one 3/8" hole at one of the marked locations in wall. (See Figure 2)

3.Install either one Fischer UX 10 x 60 anchor [Part number 077871] (not included) or one Hilti HUD-L 10x70 anchor (not included) into one of the drilled holes. (See Figure 2)

4.Install one Grade 2 or better 5/16 x 2-1/2" hex head lag screw (not included) through one Grade 2 or better 5/16" washer (not included), one mounting hole in wall bracket and into one Fischer or Hilti anchor (not included). (See Figure 2)

5.Level wall bracket using attached bubble level.

6.Make any necessary corrections to remaining mounting hole marking(s).

7.Repeat Steps 2 through 4 for remaining mounting hole(s).

1	x 4 (dual stud)
2	x 2 (single stud)
	(G)
4	3	anchors
	fasteners
	(Single stud fasteners/anchors shown in gray)

Figure 2

NOTE: Proceed to Installing Short Throw Projector Arm to Bracket section to continue installation.

6 Visit the InFocus support site at www.infocus.com/support