InFocus PRJ-WALLKIT-13 installation instructions Wood Studs, Steel Studs

Installation Instructions PRJ-WALLKIT-13

Wood Studs

1.Using a stud finder and wall plate/bracket assembly, mark four preliminary mounting holes (dual stud) over center of wood studs, or two mounting holes (single stud) in wall plate. (See Figure 3)

2.Drill one 7/32" hole at marked location in wall. (See Figure 3)

3.Install one Grade 2 or better 5/16 x 2-1/2" hex head lag screw (not included) through one Grade 2 or better 5/16" washer (not included), hole in wall bracket and into drilled hole. (See Figure 3)

Steel Studs

IMPORTANT ! : See Site Requirements section before proceeding with Steel Studs installation to ensure installation site meets requirements! The drywall must have a minimum thickness of 1/2"!

1.Using a stud finder and wall plate/bracket assembly, mark four preliminary mounting holes over center of steel studs, or two mounting holes (single stud) in wall plate. (See Figure 4)

2.Drill one 1/2" hole at marked location on wall. (See Figure 4)

3	x 4	(Dual stud)
		(G)
	1	x 4
	2
		(Single stud)
1
	x 2
2
3	x 2

Figure 3

4.Level wall bracket using attached bubble level.

5.Make any necessary corrections to remaining mounting hole marking(s).

6.Repeat Steps 2 and 3 for remaining mounting hole(s).

NOTE: Proceed to Installing Short Throw Projector Arm to Bracket section to continue installation.

	(Dual stud)
	1
	x 4
	2
	(Single stud)
1
	x 2
2
3	x 2

Figure 4

3.Hold metal channel on Toggler® 1/4-20 (BB) Snap-Toggle (not included) flat alongside plastic straps and slide channel through hole. (See Figure 5)

Drywall
Plastic Straps	3
x 4

Figure 5

Visit the InFocus support site at www.infocus.com/support 7