Timer
Auto Off Time: automatically turns the projector off after no signals are detected for a preset number of minutes. If an active signal is received before the projector powers down, the image will be displayed.
High Altitude Setting
High Altitude: We recommend you turn on the High Altitude Mode when your envi- ronment is between 5000' (1500m) and 10,000' (3000m) above sea level.
Network
Wired LAN
DHCP: Abbreviation for Dynamic Host Configuration Protocol. This protocol automatically assigns IP Addresses to networked devices.
•When the “DHCP” is set to “On”, the DHCP server will assign an IP address to the projector automatically. This may take up to a minute.
•When the "DHCP" is set to "Off", the user will need to set the IP address manually.
IP Address: The numerical address used to identify devices on the net- work. This is only accessible when DHCP is set to Off.
•The IP Address is the number that identifies this projector on the network. You cannot have two devices with the same IP Address on the same network.
•The IP Address “0.0.0.0” is prohibited.
Subnet Mask: A numeric value defining the number of bits used in an IP Address when the network is divided into subnets. This function can only be used when DHCP is set to Off.
•The Subnet Mask “0.0.0.0” is prohibited.
Default Gateway: A server (or router) to communicate across networks (subnets) that are divided by a Subnet Mask. This function can only be used when DHCP is set to Off.
DNS: Setup DNS server address when DHCP is disabled.
MAC Address: Abbreviation for Media Access Control Address. A MAC Address is a unique ID number assigned to each network adapter. Apply: Save and execute the wired network settings.
Wireless LAN
SSID: Display the projector’s SSID information.
IP Address: a
Subnet Mask: a
Restart Network: Restart network settings.
Status/Service:
Source Info: a
Projector Info: a
Reset Lamp Hours: resets the lamp hours used counter in the Projector Info menu to zero. Do this only after changing the lamp.
Factory Reset: restores all settings to their factory default settings.
Service Code: only used by authorized service personnel.
30