InFocus PZ339-A000-00 manual LiteBoard Wand, How to Use the Wand, Charging the Wand’s Battery

LiteBoard™ Wand

The optional LiteBoard™ Wand (p/n HW-LBWAND-02), when combined with the LiteBoard Wand dongle (p/n HW-LBRADIO), works like a wireless mouse - but one that works in midair, not on your desktop. Just hold the wand in your hand, and point it at the projected image to point, click and drag. The wand works with all your software, just like a regular mouse.

Charging the Wand’s Battery

When the wand’s red battery light starts to blink, its internal battery is low (if the battery is fully discharged, you won’t be able to turn the wand on by pressing its tip, left or right mouse buttons).

To charge the battery, open the flap on the right side of the wand to expose the wand’s USB connector. Then connect a USB cable between the wand and a USB power adapter (not included), or a computer (if connecting to a computer, make sure the computer is powered on). The battery light will stay on while the battery is charging, then it will turn off when the battery is fully charged.

When charging is finished, you can disconnect the USB cable (or keep the cable connected and use the wand while it’s charging).

NOTE: 5-10 minutes of charging is enough for about an hour of wand use. A full charge will take 3-4 hours and will allow 20-40 hours of non-stop wand use. A fully charged, new wand will hold a charge in standby for up to 3 weeks.

Caution: The lithium battery is only rechargeable, and is not user serviceable or user replaceable.

Caution: Always use a USB cable and power adapter (or your computer) to charge the wand.

How to Use the Wand

1Connect the LiteBoard™ Wand dongle (p/n HW-LBRADIO) to the LiteBoard Radio connector of the projector.

2The projector needs to be powered on and connected to your computer.

3Connect the projector and your computer with a USB cable (USB Type A to USB Type B).

4Connect the projector and your computer with a VGA cable.

5Make sure the wand's battery is charged or charging.

6Turn on the projector and make sure it's displaying the computer's screen - set the source to Computer 1 or Computer 2 (press the source button on the projector or its remote if needed - you may need to press it several times).

7Enable the LiteBoard™ Wand in the Advanced Menu > Setup > Keypad/ Remote menu.

8Turn on the wand by pressing its tip, left or right mouse button - 2 blinks of the blue status light means the wand is searching for a connection. When connected the light will be lighted continuously.

9Point the wand at the screen to point, click, and drag - just like a normal mouse.

NOTE: When you’re done, set the wand aside and make sure it isn’t pointing at the screen; it will turn itself off automatically after 1 minute.

52