Wired LAN connection
Internet
IP Router
1Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the other end to the RJ45 port .
2Press Menu on the keypad or remote and then go to Advanced Menu > Setup > Network > Wired LAN menu.
( Wired LAN ) |
|
|
|
| MDL: IN2128HDa |
|
|
|
|
| FW: X.XX |
DHCP | ◄ On ► |
|
|
| |
IP Address | 192. | 168. | 0. | 160 | |
Subnet Mask | 255. | 255. | 255. | 0 | |
Default Gateway | 192. | 168. | 0. | 1 |
|
DNS | 0. | 0. | 0. | 0 |
|
MAC Address | 8C. 9A. 77. 00. 00. 01 | ||||
Apply | Execute |
|
|
| |
Previous
3Press v to highlight DHCP and press < or > to select On.
4Press v to highlight Apply and press >.
5Please wait for around 15 - 20 seconds, and then
•If the Projector IP Address still does not display, contact your network administrator.
•If the RJ45 cables are not properly connected, the IP Address, Subnet Mask, Default Gateway, DNS and MAC Address settings will display 0.0.0.0. Make sure the cables are properly connected and perform the procedures above again.
•If you need to connect to the projector in its standby mode, set the Power Saving Mode feature to Off.
If you are in a non-DHCP environment:
1Repeat steps
2Press v to highlight DHCP and press < or > to select Off.
3Contact your network administrator for information on the IP address, Subnet Mask, Default Gateway and DNS settings.
4Press ^ or v to select the item you want to modify.
5Press < or > to move the cursor and then press ^ or v to select the value.
6Press v to highlight Apply and press > to save the settings.
•If the RJ45 cables are not properly connected, the IP Address, Subnet Mask, Default Gateway, DNS and MAC Address settings will display 0.0.0.0. Make sure the cables are properly connected and perform the procedures above again.
•If you wish to connect to the projector in its standby mode, be sure to select RJ45 and obtain the IP Address, Subnet Mask, Default Gateway, DNS and MAC Address information when the projector is on.
39
