InFocus ScreenPlay 7210 manual Connecting a video device, Connecting the power cable

Connecting a video device

If your video device has more than one output, select the highest quality one. DVI video has the best quality, followed by Component video, S-video, and then composite video.

If the video device uses component cable connectors, plug the cable’s green connectors into the green component-out connector on the video device and into the green component connector (labeled “Y”) on the projector. Plug the component cable’s blue connectors into the blue component-out connector on the video device and into the blue component connector (labeled “Pb”) on the projector. Plug the component cable’s red connectors into the red component-out connector on the video device and into the red component connector (labeled “Pr”) on the projector.

If the video device uses a round, four-prong S-video connector, plug an S-video cable into the S-video connector on the video device and into the S- video connector on the projector.

If the video device uses a yellow composite video connector, plug a compos- ite video cable’s yellow connector into the video-out connector on the video device. Plug the other yellow connector into the yellow Video connector on the projector.

connect component cable

connect S-video cable

connect composite video cable

M1-DA 1	vesa 2	7	D5 8	trigger 1
		video
				trigger 2
	serial control	4
		5
		s-video
	3	6
	component	component

M1-DA 1	vesa 2	7	D5 8	trigger 1
		video
				trigger 2
	serial control	4
		5
		s-video
	3	6
	component	component

connect M1-D cable

If the video device uses a DVI connector, plug an M1-D cable into the video- out connector on the video device. Plug the other connector into the M1-DAconnector on the projector.

If the video device uses a VESA connector, plug a VESA cable into the	connect VESA cable
video-out connector on the video device. Plug the other connector into the
VESA connector on the projector.

Connecting the power cable

Connect the power cable to the connector on the back of the projector and to	connect power cable
your electrical outlet. The Power LED on the keypad turns solid green.
NOTE: Always use the power cable that shipped with the projector.

M1-DA 1	vesa 2	7	D5 8	trigger 1
		video
				trigger 2
	serial control	4
		s-video5
	3	6
	component	component

8