Settings menu

Settings menu

Audio: allows adjustments to the volume. Also allows you to turn on and off the Internal speakers and assign a particular source to a specific audio input. If your HDMI source has problems with its audio stream, you can mute it by selecting HDMI Noise Cancel.

Monitor Out Default: Determines the source (either Computer 2 or Computer

3)which is output through the Monitor Out connector. Computer 2: Out- puts Computer 2 unless current source is Computer 3 (in that case output Computer 3 instead). Computer 3: Outputs Computer 3 unless current source is Computer 2 (in that case output Computer 2 instead). Off: Outputs the current source if it is Computer 2 or Computer 3. Otherwise do not out- put any signal.

Sources: allows you to assign a particular input to a specific source key when using the remote. Also allows selection of a default Startup Source and enables or disables Autosource.

Sources>Power-up Source: this determines which source the projector checks first for active signal during power-up.

Sources>Autosource: When Autosource is not checked, the projector defaults to the source selected in Powerup Source. If no source is found, a blank screen displays. When Autosource is checked, Powerup Source determines which source the projector defaults to at power-up. If no signal is present, the projector checks the sources in order until a source is found or until power down.

System>Rear: reverses the image so you can project from behind a trans- lucent screen.

Ceiling: turns the image upside down for ceiling-mounted projection.

WARNING: To prevent eye injury if the projector is ceiling mounted, wear protective eyewear before opening lamp door. A warning sticker is included with the user documentation. Place this sticker on the lamp door if the projector is mounted on the ceiling.

IR Receivers: turns individual IR receivers off or on to avoid environmen- tal interference.

Auto Power: When Auto Power is checked, the projector automatically goes into the startup state after the projector is powered on. This allows control of ceiling mounted projectors with a wall power switch.

Display Messages: displays status messages (such as “Searching”) in the lower-left corner of the screen.

Settings menu

Audio

Sources

Powerup

 

Source

IR Receivers

System

33

Page 34
Image 34
InFocus W59, QR80421 manual Settings menu, Audio, Sources, IR Receivers System