3Replace the battery cover.
Cautions
•Batteries should not be exposed to excessive heat, such as sunshine, heat registers, or fire.
•Battery chemicals can cause a rash. If the batteries leak, clean the battery compartment with a cloth. If chemicals touch your skin, wash immediately.
•Make sure that batteries are disposed of correctly. Do not burn or incinerate.
Notes
•Do not mix batteries of different types.
•Do not mix old and new batteries.
•Remove batteries when the charge is depleted.
•If the remote control is not going to be used for an extended period of time, remove the batteries.
Aiming the remote control
To aim the remote control:
•Point the remote control towards the remote sensor on the front of your TV.
Notes
•Do not expose the remote control to shock or liquids.
•Do not use the remote control in an area with high humidity.
•Do not place the remote control in direct sunlight.
•Do not place objects, such as furniture, between the remote control and the remote sensor.
•The remote control may not work if direct sunlight or bright light shines on the remote sensor. Either move your TV or change the angle at which you use the remote control.
Using the remote control holder
Your TV comes with a remote control holder you can put the remote control in when you are not using it. You can put the holder on a table or mount it on a wall.
Screws (not | Tape |
included) |
Tips
•Different types of walls may require different types of screws. If you want to wall mount the remote control holder, make sure that you use the correct screws for the type of wall. (Screws are not provided.)
•The remote control holder is shipped with separate adhesive tape for wall mounting. This tape may not work with all types of walls. Make sure that you use the correct tape for the type of wall.
Programming your universal Insignia remote control
To program your remote control:
1Find the codes for the devices you want to program in “Manufacturers’ codes” on page 46 and write them down or highlight them.
2Turn on the device (for example, a DVD player) and, if needed, load media such as a DVD.
3Press the device button on the TV remote for the device that you want to program (TV, DVD, STB, or AUX).
4Press and hold SET until the red LED blinks twice, then release.
5Enter the first
Note
If the LED does not blink twice, repeat steps 2 to 4 and try entering the code again.
6Aim the remote at the device and press
(power). The device should turn off. If it does not, repeat Steps 3 through 5, trying each code for your brand until you find one that works. If you cannot find a code that works, see “Searching for your code” below.
7Repeat Steps 1 to 5 for the other devices you want to control. For future reference, write down each working device code.
Searching for your code
If your device does not respond to the remote control after trying all codes listed for your brand, or if your brand is not listed, try searching for your code.
To search for your code:
1Turn on the device you want to control.
2Press the device button on your TV remote control (TV, DVD, STB, or AUX) once.
3Press and hold SET until the red LED blinks twice, then release.
4Enter 9 9 1. The LED blinks twice.
5Press the number that matches your device type.
•
•
•
•
6Aim the remote at the device and press
(power). The remote sends IR codes from its library to the selected device, starting with the most popular code first. If the device responds, go to Step 8.
7If the device does not respond, press CH 
and the remote tests the next code for that device type. Continue to press CH 
until the device turns off.
Note
Press CH 
to try the previous code.
10 | www.insigniaproducts.com | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
