Insignia
Installing your shelf system | Basic setup |
Install your shelf system on a stable flat surface. There must be sufficient room in front of your shelf system for the disc tray to open. Positon your shelf system so that it can have a direct line of sight to the remote control.
Caution
•Do not install this shelf system in a confined space such as a bookcase.
•Do not expose your shelf system to extremes of temperature or humidity.
•Avoid placing your shelf system on a hot surface such as on top of other hot running equipment.
•Make sure that there is adequate ventilation to your shelf system.
Notes
•Connect the AV cord only after the speakers, antenna, and all optional equipment have been connected.
•Never make or change any connections with power turned on.
Using your DVD shelf system
Getting started
To get started:
1Finish the connection for the shelf system as shown in the previous section.
2Connect power to your shelf system.
3Turn on the TV and set to the correct
To turn your shelf system on:
1Plug in your shelf system. The standby indicator on the front panel lights up.
2Press 
Standby/On. After a few seconds the display shows “NO DISC.”
3Turn on your television and select the AV input that your shelf system is connected to.
To start playback:
1Press 
(OPEN/CLOSE). The disc tray opens.
2Place a DVD in the disc tray, then press 
(OPEN/CLOSE). The player reads the disc and starts playback. Before the movie starts to play, a menu appears.
3Select PLAY MOVIE, then press OK. The movie starts.
4Although you can watch a movie immediately, to get the best results from your shelf system,
press 
STOP, then complete the following system setup options. You only need to do this when you first set up your shelf system.
To use the basic setup menus:
1Press SETUP/EXIT on the remote control to enter the System Setup menu in stop mode.
To exit the System Setup menu, press SETUP/EXIT again.
2Press 
or 
to navigate to one of these menus: System Setup, Language Setup, Video Setup, or Audio Setup.
3When a menu is highlighted, press 
or 
to select options within the menu.
Available options for each setting appear on the right side of the screen.
4Press 
or OK to move to the right column.
5Press 
or 
to select a new setting, then press OK to confirm the changed setting.
6Repeat Steps 3 to 5 to change the other settings. For more information, refer to appropriate sections in this guide.
7When you have finished making changes, highlight EXIT/SETUP, then press OK, or press SETUP/EXIT again to exit the System Setup menu.
10 |