Note | If you press EXIT in the process of AUTO | Note | It may take a few seconds for a digital |
| SETUP, the STARTING SETUP stops and |
| channel picture to appear on screen after |
| changes to the television screen. |
| being selected. |
|
|
|
|
•When you make a menu selection, your changes occur immediately. You do not have to press EXIT to see your changes.
•When you are finished programming the menus, press EXIT.
Using the menu
To access the menu using the TV buttons:
Press both of the volume 
and 
buttons at the same time. The menu screen appears
To access the menu using the remote control:
Press MENU. The menu screen appears.
To select a setting using the TV buttons:
Use the channel 
and 
buttons and volume 
and 
buttons.
To select a setting using the remote control:
Use the channel | and | buttons and volume |
and 
buttons.
Setting the language
You can choose from three different languages (English, French, and Spanish) for the
To select a menu language:
1Press MENU. The menu screen appears.
Note If no buttons are pressed for more than 15 seconds, the menu screen returns to normal television operation automatically.
2Press 
or 
to select SETUP menu.
3Press 
or to 
select LANGUAGE.
4Press 
or 
to select the desired language: English (ENGLISH), French (FRANÇAIS), or Spanish (ESPAÑOL).
5Press EXIT to return to the normal screen.
Memorizing channels
This television is equipped with a channel memory feature which allows channels to skip up or down to the next channel set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the television’s memory. This television can receive up to 250 VHF/UHF channels and 500 cable television channels.
To use this television with an antenna, set the TV/CABLE menu option to the TV mode. When shipped from the factory, this menu option is in the CABLE mode.
Selecting TV or cable
To select TV or cable input:
1Press MENU. The menu screen appears.
2Press 
or 
to select the SETUP menu.
3Press 
or 
to select TV/CABLE.
4Press 
or 
to select TV or CABLE.
•
•
5Press EXIT to return to the normal screen.
Cable chart
The following chart is typical of many cable system channel allocations. The number on the top is the number on the television. The number or letter on the bottom is the corresponding cable channel.
Automatic memory tuning
To automatically memorize channels:
1Press MENU. The menu screen appears.
2Press 
or 
to select the SETUP menu, then press 
or 
to select AUTO CH MEMORY.
3Press 
or 
. The television begins memorizing all of the channels available in your area.
Depending on the reception condition, it may take approximately ten minutes to complete memorizing digital cable channels.
Note Some new channels may be added. You should complete the AUTO CH MEMORY procedure periodically.
Adding and deleting channels
To add or delete channels:
1Press MENU. The menu screen appears.
2Press 
or 
to select the SETUP menu, then press 
or 
to select ADD/DELETE.
3Press 
or 
. The ADD/DELETE menu appears.
4Press 
or 
to select ADD/DELETE, then press 
.
5Select the desired channel to be memorized or deleted using 
or 
.
6Press 
or 
to select ADD or DELETE.
7Repeat step
8Press EXIT to return to the normal screen.
Note To return from the ADD/DELETE menu to the SETUP menu, select SETUP MENU,
then press 
or 
.
To add digital channels:
1Select the digital channel you want to add using the direct channel selection (number) buttons.
2Press MENU. The menu screen appears.
3Press 
or 
to select the SETUP menu, then press 
or 
to select ADD/DELETE.
4Press 
or 
. The ADD/DELETE menu appears.
9 |