NS-FTV27 27-inch Flat Stereo Color TV

Setting up your television

2 Install two AAA batteries (not supplied).

 

Connecting your television to AC power

Use the AC polarized cord provided for operation on AC. Insert the AC plug into a standard 120V 60Hz polarized AC outlet.

AC outlet

Wider hole and blade

Polarized AC plug (one blade is wider than the other.)

3Replace the battery compartment cover.

Battery precautions

Follow these precautions when using batteries in this remote control:

Use only the size and type of batteries specified.

Notes

• Never connect the AC plug to other

 

than the specified voltage (120V

 

60 Hz). Use the attached power cord

 

only.

 

• If the polarized AC cord does not fit into

 

a non-polarized AC outlet, do not file or

 

cut the blade. It is your responsibility to

 

have an electrician replace the

 

obsolete outlet.

 

• If you cause a static discharge when

 

touching the television and the

 

television fails to work, unplug the

 

television from the AC outlet, then plug

 

it back in. The television should work

 

normally.

 

 

Installing batteries in the remote control

Before using the remote control, you must install batteries. Use two AAA size batteries (not supplied). The batteries may last about one year depending on how much the remote control is used. For best performance, we recommend the batteries should be replaced on a yearly basis, or when the remote operation becomes erratic. Do not mix old and new batteries or different types.

To install batteries in the remote control:

1Open the battery compartment cover.

Make sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may damage the device.

Do not mix different types of batteries together (such as alkaline and carbon-zinc) or old batteries with fresh ones.

If the remote is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

Do not try to recharge batteries that are not intended to be recharged. These batteries can overheat and rupture (follow battery manufacturer's directions).

Connecting to an antenna

If you are using an indoor or outdoor antenna, follow the instructions that correspond to your antenna system. If you are using a cable television service, see “Connecting to cable television” on page 6.

Combination VHF/UHF antenna (single 75 ohm cable or 300 ohm twin-lead wire)

75ohm coaxial cable

RF IN jack

300-75 ohm RF IN jack matching

transformer

1Connect the 75 ohm cable from the combination VHF/UHF antenna to the RF IN jack.

2If your combination VHF/UHF antenna has a 300 ohm twin-lead wire, you may need to use a 300-75 ohm matching transformer.

www.insignia-products.com

5