Insignia NS-LCD37 manual 15

Insignia NS-LCD37 LCD TV

5Press EXIT to return to watching the television.

You can use the CH+/- buttons to cycle among the viewable channels. Not viewable channels are skipped.

Note

You can use the Manual Channel Set Menu to select a channel you want to view.

Monitoring DTV signal strength

You can use the DTV signal strength monitor to check how strong your DTV signal is, and then determine if you need to adjust your antenna or digital cable input. The higher the signal strength, the less likely you are to experience picture degradation.

To monitor DTV signal strength:

1Press MENU.

2Press or to select Setup menu, then press OK or to access the submenu.

3Press or to select DTV Signal, then

press OK or to view the on-screen signal strength monitor and see the quality of the signal being received.

Labeling channels

If a channel is not already labeled, you can label the channel so you know what channel you are watching.

Note

If a channel label is provided on the signal from the broadcasting station, the television displays the short name for the DTV channel, even if you didn’t set up a label for that channel.

To label your channels:

1Press MENU.

2Press or to select Setup menu, then press OK or to access the submenu.

3Press or to select Channel Labels,

then press OK or to view the Channel Labels Menu.

4Within the menu, press or to move the highlight or cursor. Press or to select the channel number, or select a character. Press OK to return to the previous menu.

5Press EXIT to return to watching the television.

Selecting channels

You can use one of three methods to select a channel:

•Use the number pad

•Use the CH+ and CH- buttons

•Use the previous channel button

Using the number pad

To go to a specific channel number:

•Press the number buttons (0-9) and the dash (-) button, then wait for the television to change channels, or press OK to go immediately to that channel.

For example, if you want to select channel

8-3, press 8-3 on the remote control. (Make sure that you press the buttons within three seconds of each other, or the channel won’t be entered correctly.)

Note

In some situations, virtual channel numbers do not correspond to physical frequencies.

Using the CH+ and CH- buttons

To browse through the channels:

•Press:

•CH+ to browse up the channels.

•CH- to browse down the channels.

Using the previous channel button

To switch between two channels:

•Press the previous channel button to switch between the current channel and the previous channel.

Information about USA channel numbering

•The ATSC PSIP channel uses a two part channel number which includes:

•a major channel number

•a minor channel number

Note

Example: Channel 5-1. The “5” is the major channel number and the “1” is the minor channel number.

•In the US, in most locations the major channel number is the same for both analog and digital channels (It is equal to the NTSC channel number for existing broadcasters.)

•In the US, a minor channel number of zero is used for a broadcaster's analog channel.

www.insignia-products.com 13