Integra DTR-8.3 Connecting antennas

25

Directional linkage

Do not use the same antenna for both FM and TV (or VCR)

reception since the FM and TV (or VCR) signals can interfere with

each other. If you must use a common FM/TV (or VCR) antenna, use

a directional linkage type splitter.

Connecting the antenna cable to the 75/300 Ω

antenna adapter (Australian model only)

Connecting the 300 Ω ribbon wire:

Loosen the screws on the adapter and wrap the wires of the ribbon

wire around these screws. Then tighten the screws down with a

screwdriver.

Connecting the coaxial cable:

1. With your fingernail, or a small screwdriver, press the

stoppers of the 75/300 Ω antenna adapter outward and

remove the cover.

2. Remove the transformer wire A from slit B and insert it

into slit C.

3. Prepare the coaxial cable as shown in the diagram.

4. Connect the 75/300 Ω antenna adapter to the coaxial

cable.

1. Insert the end of the cable.

2. Clamp it in place with pliers.

5. Reinstall the cover.

Connecting antennas

Outdoor antenna

(Indoor)

AM loop antenna

To TV (or VCR)To receiver

Connecting an FM outdoor antenna

Make sure to follow the general rules given below:

•Keep the antenna away from noise sources (neon signs, busy

roads, etc.).

•It is dangerous to put the antenna close to power lines. Keep it

well away from power lines, transformers, etc.

•To avoid the risk of lightning and electrical shock, grounding is

necessary. Follow item 14 of the “Important Safeguards” on

page 2 when you install the outdoor antenna.

Connecting an AM outdoor antenna

If reception is poor with the indoor AM antenna, stretch out the

outdoor antenna (16 feet (5 meters) or more) above a window or

outside.

•Keep the indoor AM loop antenna connected. Do not remove it.

•To avoid the risk of lightning and electrical shock, grounding is

necessary. Follow item 14 of the “Important Safeguards” on

page 2 when you install the outdoor antenna.

AUDIO

P

RE OUT

L

L

AM

FM

75

RL

CENTER

ANTENNA

AUDIO

P

RE OUT

L

L

AM

FM

75

RL

CENTER

ANTENNA

Outdoor

antenna

300 Ω

ribbon wire

1 2 3, 4

✦✦✦

✦✦✦✦

✦

✦✦

✦

6

mm

3

mm

6

mm

5/8"

(15mm)

Slit B

Wire A

Slit C

Contents

Main Contents DTR-8.3 AV Receiver Instruction Manual Important Safeguards WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: WARNING Precautions NOTE: CAUTION: REMARQUE: ATTENTION: Contents Contents Features Amplifier Features Audio/Video Features FM/AM Tuner Features Other Performance Features Before using this unit Connecting the power cord Standby indicator Approx. 16 feet 30 30 Setting up the remote controller Characterizing the remote controller Setting up the remote controller Touch the screen to start Home menu Components control panel Page Front panels Front panel display Rear panels Remote controller Page Connecting to Audio/Video equipment Connecting your audio components Connecting your video components Page Page Page Connecting speakers Ideal speaker configuration Minimum speaker configuration for surround sound playback Speaker placement Connecting speakers Connecting speakers NO! Center Subwoofer Surround Back left speaker Connecting antennas Directional linkage Connecting the antenna cable to the 75/300 antenna adapter (Australian model only) Connecting antennas Connecting an FM outdoor antenna Connecting an AM outdoor antenna When using the SURR BACK/ZONE 2 SPEAKERS terminals When using the SURR BACK/ZONE 2 PRE OUT terminals Connecting the remote zone (Zone 2) speakers If the remote controller signal does not reach other components Operating components not reached by the remote controller signals (IR IN/OUT) If the remote controller signal does not reach the DTR-8.3 remote sensor Connecting the power cords from other devices RS 232 port Connections for remote control ( ) Miscellaneous Connections Connecting auxiliary power amplifier Power amplifier 87654321 Connecting to an external device with 12V TRIGGER terminal Miscellaneous Connections Ex: DVD-Audio player/MPEG decoder 1. Front left speaker 2. Front right speaker 3. Subwoofer 4. Surround back left 5. Surround back right 6. Surround left speaker 7. Surround right speaker 8. Center speaker Connecting the power Basic operation Enjoying music or videos with the DTR-8.3 Changing the listening mode Switching the display Temporarily turning off the sound Adjusting the bass and treble Listening with headphones Adjusting the brightness of the front display Sleep Dimmer Temporarily changing the speaker output levels Dim CH Sel Changing the audio mode Enjoying the multichannel output Listening to Radio Broadcasts Tuning into a radio station Listening to a stereo radio station (FM mode) Selecting a preset radio station Erasing a preset radio station Listening to Radio Broadcasts Presetting a radio station To record the input source signal you are currently watching or listening to Recording a source To record an input source signal different from that you are currently watching or listening to Recording a source Recording the video from one source and the audio from another Off Zone 2 Enjoying music or videos in the remote zone Using the buttons on the DTR-8.3 Enjoying music or videos in the remote zone Adjusting the volume for the remote zone Selecting an input source using the remote controller Setup Menu Setup Menu Navigating through the Setup Menu 0. Hardware Setup Menu Hardware Setup 0-1. Speaker Impedance Sub-menu Hardware Setup 0-2. Surr Back/Zone 2 Sub-menu 0-3. IR IN Setup Sub-menu 1. Speaker Setup Menu 1-1. Speaker Config Sub-menu Speaker Setup Speaker Setup 1-2. Speaker Distance Sub-menu 1-3. Level Calibration Sub-menu Input Setup 2. Input Setup Menu 2-1. Digital Setup Sub-menu (When NET AUDIO is not selected as the input source) 2-2. Multichannel Setup Sub-menu (When NET AUDIO is not selected as the input source) 2-3. Video Setup Sub-menu 2-4. Character Input Sub-menu 2-6. Listening Mode Preset Sub-menu 2-7. 12V Trigger Setup sub-menu 2-5. IntelliVolume Sub-menu Page Page Page Audio Adjust 3. Audio Adjust Menu 3-1. Tone Control Sub-menu 3-2. Surround Speakers Sub-menu 3-3. Sound Effect Sub-menu 3-4. Delay Sub-menu 3-5. LFE Level Sub-menu 3-6. Mono Sub-menu 3-7. Theater-Dimensional Sub-menu 3-8. Surround Sub-menu 3-9. THX Sub-menu Settings possible for each listening mode (3-1. 3-2. 3-3. Sub-menu) 4-1. Volume Setup Sub-menu Preference 4. Preference Menu 4-4. OSD Position Sub-menu 4-2. Headphones Level Sub-menu 4-3. OSD Setup Sub-menu Preference Setting Adjusting Setting Function Using the Remote Controller Using the Remote Controller Working with Modes Using the Remote Controller Selecting a Device Define the Brand of Your Device Define the Brand of Your Device Define the Brand of Your Device Defining brands by searching Programming Buttons Programming control panel buttons Programming device items Programming Buttons Programming direct-access and Left/Right Buttons Labeling Buttons and Menu Items Labeling a button Labeling a menu item Adding and Moving Devices Adding devices Adding macros Moving menu items Restore Delete and restore Delete Recording Macros and Setting Timers Recording macros Editing macros Recording Macros and Setting Timers Setting timers Organizing macros and timers into groups Changing the remote controllers RF IR Settings Using the remote controller with Radio Frequency (USA & Canadian models only) Using the remote controller with Radio Frequency (USA & Canadian model only) Choosing Another Channel ChadEdit Additional information Optional recharging dock (USA and Canadian models only) FAQ Overview of Symbols Troubleshooting guide POWER SPEAKERS FM/AM TUNER VIDEO and AUDIO OTHER REMOTE CONTROLLER If one of the messages shown below appears Specifications Specifications and features are subject to change without notice. Specifications Page System Requirements Features Internet radio features Net-Tune Features DTR-8.3 How to Enjoy Net Audio Connecting the DTR-8.3 to your Ethernet Network Hint: 5. Press the Select button. 6. Use the / button to select one of the radio stations. 7. Press the Select button. Enjoying Music on Internet Radio or the Audio Network Server Net Audio iNet RadioMusic Server 4. Press the Play button to play the music file. To stop playback: Enjoying Music on Internet Radio or the Audio Network Server + Enjoying Music on Internet Radio or the Audio Network Server 1. Press either the Album, Artist, Genre, or Playlist button on the remote controller. 2. Use the / buttons to select one of the menu. Using the Alphanumeric keys 4. Press the Select button. Configuring Various Settings Configuring Various Settings 5-1. IP Address Sub-menu 5-2. Proxy Setup Sub-menu 5-3. MAC Address Sub-menu E Appendix 5-4. Client Sub-menu Configuring Various Settings Troubleshooting guide The playback sound discontinues while using the Music Server.